Оценок - , средний балл:
(
)
)
Производитель: Audiovox
Размер: 62.8 kb
Название файла: a8f5175b-5561-4691-bb3e-f94b96773ae7.pdf
Язык инструкции:
Документ загружается, подождите пожалуйста
 |
Документ загружается, подождите пожалуйста
Фрагмент инструкции
Power On/Off Switch 3. Remote Control Sensor 4. Picture Select 5. On Screen Adjustment Up Button 6. On Screen Adjustment Down Button 4 To IR Tansmitter (Optional) 10 9 7 8 12 11 REAR PANEL To Optional IR Transmitter Part Number IRT456 NOTE(B) NOTE(A) 7. Power Input Connector: Red = +12 VDC Black = ground 8. Video Signal Input Connector 9. IR Repeater Connector 10. IR Repeater Transmitter 11. Audio Right Channel Input Connector 12. Audio Left Channel Input Connector 5 Note A : This cable (10) is utilized to connect to Video Cassette Players that do not accept the IR Repeater 1/8" (3.5mm) style plug (9). The IR Repeater Transmitter isprovided with an adhesive that allows it to adhere toVideo Cassette Player remote sensor. Remove thebacking covering the adhesive and place the IR Repeater Transmitter directly over the Video CassettePlayer remote sensor. Note B : Connector (11) and (12) are Audio input Jacks reservedfor optional IR Wireless Transmitter use (IRT456). IR Wireless Transmitter is a device for transmitting(audio sound without using wires) to IR Headphones. Please contact Audiovox dealers for this optional accessory. OPERATION 1. Connect the monitor power input plug (7) to a DC powersource (Red plug +12 VDC, Black plug (-) to ground). 2. Connect the external video source output signal (from VCP/ DVD, TV Etc.) to the VIDEO IN jack (8). 3. Press power On/Off button (2) to turn the monitor on and off. The LED power indicator will light red. 4. Press the Picture Select button (4) to adjust the picture display characteristics. The adjustments will be shown on theOn Screen Display in the following sequence: Contrast, Brightness, Color, and TINT. 5. While in the picture select mode (video adjustment), pressthe up button (5) to increase the selected adjustment levelor press the down button (6) to decrease the level. 6 GENERAL INSTALLATION INFORMATION 1. Installation will vary from vehicle to vehicle, as headrests invehicles are not standard. 2. This unit is intended for installation by professional installers. 3. The kit consists of the screen assembly, a mounting housing, key to remove screen from housing, wiring harness, remote control unit and remote control unit batteries. 4. To release screen from housing, slide the key on either theright or left side of the screen between the housing and screenassembly to release the two clips which hold the screenassembly in the housing. 5. To install the screen assembly into the housing simply insertthe screen assembly until you hear the clips click into the locking position. 6. Headrests will have to be cut to install the screen assemblyhousing. Caution - Do not over-cut the headrest beyond the height andwidth of the housing. 7. To fasten the housing to the headrest, use either screws ortie wraps. Find a suitable mounting surface in the headrestto secure the housing. Caution - Use the proper length screws, which will vary witheach headrest. If a suitable mounting surface cannot be found, use tie wraps to s...
Эта инструкция также подходит к моделям:Мониторы - LCM-5600NP (62.8 kb)