Оценок - 2, средний балл: 4
(
)
)
|
Фрагмент инструкции
-9 128-6423 9 of 16 Operation Overhead Dome Lights The lights integrated into the VOH703 are controlled by a three position slide switch. Sliding the switch to the on position will turn the lights on. The off position will prevent the lights from turning on at all times and the auto position will allow the lights to turn on and off with the vehicle’s interior lighting. Do not leave the vehicle unattended with the dome light switch in the on position, as this could result in a discharged battery. Dome Light Switch Remote Sensor The VOH703 incorporates an Infrared sensor which relays signals from the remote control to allow the VOH703 and VCP to be controlled simply by pointing its remote control at the remote sensor eye. This provides control of auxiliary equipment such as an Audiovox Video Cassette Player. The infrared sensor can relay signals from any manufacturer’s remote controls to the component connected to the Video 1 and 2 inputs, such as a DVD player. In this case you must use the remote control supplied with the DVD player. Remote Sensor Eye Transmitters Infrared Remote Sensor Eye -10 128-6423 10 of 16 Optional AccessoriesWired Headphone There are two 1/8” headphone jacks on the VOH703 that can be used with any standard stereo headphones. The jack, TV EAR, is used to listen to the video program audio. The audio volume is controlled by the TV VOLUME up/down buttons. Remove the protective plastic cover to access the jacks. Remember to replace the cover when the jacks are not in use. Wired FM Modulator Your video system may be equipped with an RF modulator, that allows you to listen to the VOH703’s video audio signal by tuning your vehicle’s radio to the selected frequency, (88.7 or 89.1 - Check with your installer) and turning on the remote mounted RF modulator switch. (In most cases this toggle switch will be located underneath the driver’s side of the dash, check with your installer for the exact location.) Whenever the RF modulator is on, broadcast radio reception of the vehicle’s radio will be diminished. Setting the remote mounted toggle switch off will allow normal radio reception. Video Output The VOH703 provides a video output for an optional video monitor(s). (Refer to page 6 of the installation guide for more details.) This output will provide a video signal that duplicates the signal displayed by the VOH703 to an additional monitor or video display. Please see your installer for more information. Audiovox Video Cassette Player (Aux Video 1) In most installations a VCP will be connected to the “Video 1” input. To view a video cassette, turn the VOH703 On and press the source button on its control panel or the TV / Video button on the remote control until “Video 1” is displayed on the screen. The VCP may also be operated with the remote or the buttons on its face. The VOH703 is now ready to play the audio and video signals from the VCP if it is connected to the “Video 1” input. Inserting a tape into the VCP will turn it on and automatically activate the play mode. If a rewound tape had already been loaded into the VCP, prior to its activation press play on the VCP or on the remote control to view the tape. For more information see the operator’s manual accompanying your VCP. -11 128-6423 11 of 16 Aux Video 2 The second video input may be connected to a DVD player, video game system, or other audio/video input. To play the Video 2 source, turn the VOH703 on and press the source button on the VOH703 or the TV/ Video button on the remote control until “Video 2” is displayed on the screen. Turn the source component on with its power button or remote control. The VOH703 is now ready to play the audio and video signals from the source connected to video 2 inputs. -12 128-6423 12 of 16 Troubleshooting PROBLEM SOLUTION Poor TV •Perform auto programming of the tuner. reception •Verify antenna condition. • Note: Due to the nature of TV signals, vehicle motion, direction the vehicle is facing, distance from the transmitter, nearby surroundings and weather mayadversely affect TV reception. These conditions may result in the following: picture roll, "snowy" picture, or momentaryloss of color. Please refer to page 2 formore information on TV reception. Poor in-dash •Check the condition of the vehicle’s radio radio reception (antenna. modulator •Verify that the antenna is fully raised. installed) •If a wired RF modulator has been installed, verify that its switch is turned to the offposition. IR sensor •Verify that the batteries in the remote areinoperative fresh. •Verify that the remote sensor eye is notobstructed. •Verify that the infrared transmitter is affixedover the sensor eye of the component tobe controlled. -13 Replacement Parts Remote Control 136B1612 IR Sensor Cover 102B3596 Headphone Jack Cover 102B3597 Specifications LCD Backlighting Edge Light Tube Cold Cathode Fluorescent Light (CCFL) Resolution 1440 (RGB) x 234 Pixels 336,960 Operation Temperature Storage Temperature 0 - 40 °C 32 - 104 °F -...
Эта инструкция также подходит к моделям:Мониторы - VOH703 (492.3 kb)