Оценок - 2, средний балл: 4
(
)
)
|
Фрагмент инструкции
Weight: 1 lb (400g) 11. Video Format: NTSC 3 CONTROLS AND INDICATORS FRONT PANEL 1. Power On LED Indicator 2. Power On/Off Switch 3. Remote Control Sensor 4. Picture Select 5. On Screen Adjustment Up Button 6. On Screen Adjustment Down Button 4 REAR PANEL 10781211 Part Number IRT456 NOTE(B)NOTE(A) To Optional IR Transmitter 7. Power Input Connector: Red = +12 VDC Black = ground 8. Video Signal Input Connector 9. IR Repeater Connector 10. IR Repeater Transmitter 11. Audio Right Channel Input Connector 12. Audio Left Channel Input Connector 5 Note A : This cable (10) is utilized to connect to Video Cassette Players that do not accept the IR Repeater 1/8" (3.5mm) style plug (9). The IR Repeater Transmitter is provided with an adhesive that allows it to adhere to Video Cassette Player remote sensor. Remove the backing covering the adhesive and place the IR Repeater Transmitter directly over the Video Cassette Player remote sensor. Note B : Connector (11) and (12) are Audio input Jacks reserved for optional IR Wireless Transmitter use (IRT456). IR Wireless Transmitter is a device for transmitting (audio sound without using wires) to IR Headphones. Please contact Audiovox dealers for this optional accessory. OPERATION 1. Connect the monitor power input plug (7) to a DC power source (Red plug +12 VDC, Black plug (-) to ground). 2. Connect the external video source output signal (from VCP/ DVD, TV Etc.) to the VIDEO IN jack (8). 3. Press power On/Off button (2) to turn the monitor on and off. The LED power indicator will light red. 4. Press the Picture Select button (4) to adjust the picture display characteristics. The adjustments will be shown on the On Screen Display in the following sequence: Contrast, Brightness, Color, and TINT. 5. While in the picture select mode (video adjustment), press the up button (5) to increase the selected adjustment level or press the down button (6) to decrease the level. 6 GENERAL INSTALLATION INFORMATION 1. Installation will vary from vehicle to vehicle, as headrests in vehicles are not standard. 2. This unit is intended for installation by professional installers. 3. The kit consists of the screen assembly, a mounting housing, key to remove screen from housing, wiring harness, remote control unit and remote control unit batteries. 4. To release screen from housing, slide the key on either the right or left side of the screen between the housing and screen assembly to release the two clips which hold the screen assembly in the housing. 5. To install the screen assembly into the housing simply insert the screen assembly until you hear the clips click into the locking position. 6. Headrests will have to be cut to install the screen assembly housing. Caution - Do not over-cut the headrest beyond the height and width of the housing. 7. To fasten the housing to the headrest, use either screws or tie wraps. Find a suitable mounting surface in the headrest to secure the housing. Caution - Use the proper length screws, which w...
Эта инструкция также подходит к моделям:Мониторы - LCM4000 (85.5 kb)