Оценок - 1, средний балл: 5
(
)
)
|
Фрагмент инструкции
to persons are marked with this danger symbol. tips and instructions which structions to This indicates instructions these operating in- english Symbols used to mark Safety instructions in Before using the high-pressure This symbol is used cleaner, be sure to mark safety into also read the structions that must enclosed operat-be observed to preing instructions and vent damage to the ma- keep them within reach at all chine and its performance. times. 1 Important safety instructions For your own safety The high-pressure cleaner may only be used by persons instructed in its use and who have been expressly authorised to do so. Although extremely easy to operate, children should not be allowed to use the cleaner. General Use of the high-pressure cleaner is subject to the applicable local regulations. Besides the operating instructions and the binding accident prevention regulations valid in the country of use, observe recognised regulations for safety and proper use. Do not use any unsafe work techniques. Transport Transport of the high-pressure cleaner is easy on its large wheels. For safe transport in and on vehicles we recommend to prevent the equipment from sliding and tilting by fixing it with belts. Transport (when tilted): – do not tilt the machine on the front with the water connections. – remove suction hose from the detergent tank and close tank filler with the cap provided with the machine. – before putting the cleaner into operation: pay attention to allow the pump oil to run back into the pump housing. Check oil level, top up if necessary. For transport at temperatures around or below 0°C, anti-freeze should be drawn into the pump beforehand (see chapter 6). Before starting the cleaner If your 3-phase cleaner was supplied without a plug, have it fitted with a suitable 3-phase plug with earth conductor, by an electrician. Before use, check that the high- pressure cleaner is safe and in proper condition. Regularly check whether the power cord is damaged or shows signs of ageing. Use the high-pressure cleaner only when the mains power lead is in a safe condition. (risk of electric shock if damaged!). Check the rated voltage of the high-pressure cleaner before connecting it to the mains power supply. Ensure that the voltage shown on the rating plate corresponds to the voltage of the local mains power supply. We strongly recommend that the power supply to the high pressure cleaner be connected via a residual current circuit breaker. This device stops the supply of 1) Options / model variants 2 POSEIDON 5 electricity if the leakage current to earth exceeds 30 mA for 30 ms or it has an earth tester circuit. Operate the cleaner only in an upright position! Please observe the regulations and provisions applicable in your country. Before putting the high-pressure cleaner into service, carry out a visual check of all the major components. CAUTION! High-pressure water jets can be dangerous if misused. The jet must not be directed at persons, animals, live electrical equipment or the cleaner itself. Wear appropriate protective clothing and eye protectors. Do not direct the jet towards yourself or towards other persons in order to clean clothes or footwear. During operation of the cleaner, recoil forces are produced at the spraying device and, when the spray lance is held at an angle, a torque is also created. The spraying device must therefore be held firmly in both hands. Do not use the cleaner when other people without protective clothing are in the working area. Check that cleaning will not result in dangerous substances (e.g. asbestos, oil) being washed off the object to be cleaned and harming the environment. Do not clean delicate parts made of rubber, fabric, etc. with the 0° jet. Keep some distance between high pressure nozzle and surface in order to prevent the surface from damage. Do not use the high-pressure hose for lifting loads. ture are printed on the high- pressure hose. Do not continue to use the cleaner if the mains power lead or high-pressure hose is damaged. Ensure adequate air circulation. Do not cover the cleaner or operate it in inadequately ventilated rooms! Store the cleaner where it will not be exposed to frost! Never operate the cleaner without water. Even brief shortages of water result in severe damage to the pump seals. Operation CAUTION! Unsuitable extension leads can represent a source of danger. Always unwind cord from the reels completely to prevent the power cord overheating. Plugs and connectors of mains power leads must be at least splash water-proof. When using an extension cord, check the minimum cross-sections of the cable: Cable length Cross section m <16 A <25 A up to 20 m o1.5mm. o2.5mm. 20 to 50 m o2.5mm. o4.0mm. Do not damage the mains power lead (e.g. by driving over it, pulling or crushing it). Disconnect the power cord by pulling the plug only (do not pull or tug the power cord). Electrical equipment sons, risk of short-circuiting. english The cleaner may only be co...