Оценок - 3, средний балл: 4
(
)
)
|
Фрагмент инструкции
Unloader valve seat faulty or worn 1 Replace with tip of proper size 2 Clean Check more frequently 3 Check filter Replace water seals See service center 4 Clean inlet and discharge valve assemblies Check filter 5 Check garden hose, may be collapsed or kinked Check inlet water flow 6 Replace worn valves 7 Replace high pressure hose 8 Ensure hoses and fittings are tight 9 Check and replace Water leakage from under pump manifold Worn water seals Install new water seals See service center Water in pump crankcase (milky oil) 1 Humid air condensing inside crankcase 2 Oil seals leaking 1 Change oil as specified in maintenance schedule 2 Install new oil seals See service center Frequent or premature failure of the pump water seals 1 Scored damaged or worn plungers 2 Abrasive material in the fluid 3 Inlet water temperature too high 4 Overpressurizing pump 5. Excessive pressure due to partially plugged or damaged tip 6 Pump running too long without spraying 7 Pump running dry 1 Install new plungers See service center 2 Install proper filtration on pump inlet plumbing 3. Check water temperature; may not exceed 100o F. 4 Do not modify any factory set adjustments 5 Clean or replace tip 6 Never run pump more than 2 minutes without spraying 7 Do not run pump without water Strong surging at the inlet and low pressure Foreign particles in the inlet or discharge valve or worn inlet and/or discharge valves Clean or replace valves See service center Oil leakage between the Worn oil seals and/or o-ring Replace oil seals and/or o-ring See service center engine and the pump Fluctuating pressure 1 Valve worn, dirty or stuck 1 Check and replace 2 Pump drawing in air 2 Ensure hoses and fittings are tight Purge air from 3 Tip clogged garden hose 3 Check or replace Pressure drops after 1 Worn pump water seals 1 Check and replace period of normal use 2 Nozzle worn 2 Check and replace 3 Valve worn, dirty or stuck 3 Check, clean or replace 4. Unloader valve seat worn or dirty 4 Check, clean or replace 5 Nozzle in low psi position 5 Pull back nozzle to high pressure position 12 PW4035 troubleshooting Chart -Gasoline Powered Pressure Washers Only Symptom Possible Cause(s) Corrective Action Pump noisy / pump runs rough 1 Pump drawing in air/low water supply 2 Valves dirty or worn 3 Worn bearings 4 Water too hot 1 Ensure fittings are tight Increase water pressure 2 Check, clean or replace 3 Check and replace 4 Reduce temperature below 100.F Pressure washer will not spray detergent 1 Not using soap tip 2 Clog, kink, or hole in detergent suction hose 3 Hose length too long 1 Install 65 degree (black) soap tip 2 If clean, unkink or replace hose 3. Use only hose length provided with initial purchase of pressure washer Detergent suction will not function if more than one section of hose is attached to unit 4 Lance not functioning properly 4 Remove lance from gun If detergent is dispensed through gun, the lance must be replaced If no detergent is dispensed through gun, remove 1” tapered detergent barb from pump Clean the barb, and make sure that ball and spring are properly aligned with tapered portion of the spring facing the ball The ball should be on top of the spring Notes 13 Operating Instructions and Parts Manual lIMIteD WArrANtY 1. DURATION: From the date of purchase by the original purchaser as follows: Three Years 2 . WHO GIVES THIS WARRANTY (WARRANTOR): Campbell Hausfeld / Scott Fetzer Company, 100 Production Drive, Harrison, OH 45030, Telephone: 1-800-330-0712 3. WHO RECEIVES THIS WARRANTY (PURCHASER): The original purchaser (other than for purposes of resale) of the Campbell Hausfeld pressure washer 4. WHAT PRODUCTS ARE COVERED UNDER THIS WARRANTY: Any Campbell Hausfeld Pressure Washer supplied or manufactured by the Warrantor 5. WHAT IS COVERED UNDER THIS WARRANTY: Substantial defects on material and workmanship which occur within the duration of the warranty period with the exceptions noted below. 6. WHAT IS NOT COVERED UNDER THIS WARRANTY: A. Implied warranties, including those of merchantability and FITNESS FOR A PARTICULAR PURPOSE ARE LIMITED FROM THE DATE OF ORIGINAL PURCHASE AS STATED IN THE DURATION. Some states do not allow limitation on how long an implied warranty lasts, so the above limitations may not apply to you B. ANY INCIDENTAL, INDIRECT, OR CONSEQUENTIAL LOSS, DAMAGE, OR EXPENSE THAT MAY RESULT FROM ANY DEFECT, FAILURE, OR MALFUNCTION OF THE CAMPBELL HAUSFELD PRESSURE WASHER. Some States do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. C . Any failure that results from shipping damage, accident, purchaser’s abuse, neglect or failure to install and operate pressure washer in accordance with instructions provided in the owner’s manual(s) supplied with product D Pre-delivery service, i e assembly, oil or lubricants and adjustment E . Items or service normally required to maintain the pressure washer ...
Эта инструкция также подходит к моделям:Моечное оборудование - PW4035 (3.36 mb)