Оценок - 3, средний балл: 3.7
(
)
)
|
Фрагмент инструкции
Task Accessories Cleaning method Car Tornado® PR noz- zle, auto brush, underchassis spray lance, Car Combi Cleaner 1. Apply Car Combi Cleaner. Always start from the bottom and work upwards. Let Car Combi Cleaner act for at least 5 min. 2. Wash the car with the Tornado® PR nozzle. Start at the front of the car and work backwards to avoid water from penetrating by the door mouldings. 3. Use the brush for removal of traffi c film which is not removed by the nozzle. If the car is very dirty, apply Car Combi Clean er again. 4. Attach the undercarriage spray lance and clean undercarriage and wheel arches. 5. Remove water from the surface of the car with the squeegee on the car brush. Make sure that all grains of sand etc. have been removed before using the squeegee Wipe with a wash leather where the squeegee cannot reach. Rims, alu- minium Rim brush, atomizer, Alu Cleaner Apply Alu Cleaner with an automizer. Let it act for approx. 5 min. and wash with the rim brush. For steel rims, use Car Com- bi Cleaner. Wash with rim brush. Be careful! The high pressure jet may damage the tyres. Flag- stones, concrete fl oors and other hard surfaces Powerspeed® nozzle, Stone & Wood Cleaner, Patio Cleaner Wash towards outlets or the like. On surfaces with moss or algae you may start by applying Stone & Wood Cleaner. Wash before the soap dries. Another more effective and quicker method is to use the Patio Cleaner. Thus you will also avoid splashes. Garden furniture, wood Wood Cleaner Garden brush Apply Wood Cleaner and wash before the soap dries. NOTE: Use the garden brush to clean off the dirt. Brickwork, Wood work Powerspeed® nozzle, Stone & Wood Cleaner, Patio Cleaner Same method as for flagstones, but be careful -bad joints and wood may be damaged by high pressure. You may choose only to use the Tornado® nozzle. Adjust the distance (pressure) to the quality of the joints and the wood. Patio Cleaner can also be used on vertical surfaces. Gutter Underchassis spray lance Wash the gutter with the underchassis spray lance. Always wash towards down-pipes. Beware not to spray under the roofing. Cleaning of drain pipes, out- lets, down pipes etc. Tube cleaner Push the tube cleaner approx. . m (to mark) into a tube or drain and activate the trigger of the spray handle. The nozzle opening turning backwards will pull the cleaner through the tube. The nozzle will break down the „plug“ and flush the dirt backwards. Rust, paint Water/sandblasting equipment Mount the water/sand blasting equipment and rust and paint is efficiently and quickly removed. Beware not to damage the surface to be sandblasted. Green- house Tornado® PR nozzle, brush, Stone & Wood Cleaner Wash with high pressure and maybe a brush. You may use Stone & Wood Cleaner to remove moss and algae. Garden tools, lawn mover Tornado® PR nozzle, Power- speed® nozzle, Metal Cleaner Rinse the worst dirt off with the Tornado® PR nozzle. Apply Metal Cleaner and let it act for approx. 5 min. Wash with the nozzle. 12 13 Nilfisk P 130.2 / P 150.2 / P 160.2 EN . 6 After using your pressure washer 6.2 Winding up of electric cable and high pressure hose up carefully. 1. Wind up the electric cable on the appropriate hooks. Builtin clip for good holding. The lower hook can be turned to release the electric cable. 2. The high pressure washer comes in two models: A) with hook for storage of high pressure hose (14) - B) with a hose reel (13). 6.1 Storing the washer The machine should be stored in a frost-free room! Pump, hose and accessories should always be emptied of water prior to storing as follows: 1. Stop the machine (turn the start/stop switch (1) to position “O” and detach water hose and accessory. 2. Restart the machine and activate the trigger. Let the machine run until no more water runs through the spray handle. 3. Stop the machine and unplug. Wind the electric cable round the hooks placed on the side of the machine. 4. Separate spray handle and high pressure hose. 5. Machines without hose reel: Detach high pres sure hose, coil it up and place it on the hose storage. Machines with hose reel: Coil the high pressure hose up on the hose reel. 6. Place spray handle, nozzles and other ac ces so ries in the holders of the machine. Should the machine by mistake be frozen, it will be necessary to check it for damage. NEVER START-UP A FROZEN MACHINE. Frost damages are not covered by the guarantee! 6.3 Storage of accessories The standard accessories (spray handle, spray lance, nozzles and nozzle cleaning tool) can be stored on the pressure washer. To avoid accidents, the electric cable and the high pressure hose should always be wound Nilfisk P 130.2 / P 150.2 / P 160.2 EN 7 Maintenance fi lter 7.2 Cleaning of nozzle 7.3 Cleaning of machine vents 7.4 Greasing of couplings WARNING! Always disconnect the electrical plug from the socket prior to maintenance or cleaning. To ensure a long and problem free working life, please take the following advice: .Wash off water hose, high pressure hose, spr...
Эта инструкция также подходит к моделям:Моечное оборудование - P 130.2 (1.28 mb)
Моечное оборудование - P 150.2 (1.28 mb)