Оценок - 3, средний балл: 4
(
)
)
|
Фрагмент инструкции
4. After oil is drained replace oil drain plug. Tighten securely. 5. Remove oil fill cap and fill with recommended oil. See the Pump Oil Chart for the correct amount and type of oil. 6. Replace oil fill cap and tighten securely. PUMP OIL CHART Oil Fill Plug Oil Drain Plug PUMP TYPE OIL TYPE OIL CAPACITY DAPC (axial cam) * R&O 150 8 oz. * If unable to find use 30 W non detergent 13- ENG D25803 WAND If the nozzle becomes clogged with foreign materials, such as dirt, excessive pressure may develop. If the nozzle becomes partially clogged or restricted, the pump pressure will pulsate. Clean the nozzle immediately using the nozzle kit supplied and the following instructions: 1. Shut off the pressure washer and turn off the water supply. 2. Disconnect spark plug wire. 3. Pull trigger on gun handle to relieve any water pressure. 4. Disconnect the wand from the gun. 5. Remove the high-pressure nozzle from the wand. Remove any obstructions with the nozzle cleaning tool provided and backflush with clean water. 6. Direct water supply into nozzle end to backflush loosened particles for 30 seconds. 7. Reassemble the nozzle to the wand. 8. Reconnect wand to gun and turn on water supply. 9. Start pressure washer and place wand into high pressure setting to test. HOW TO CLEAN THE WATER INLET FILTER This screen filter should be checked periodically and cleaned if necessary. 1. Remove filter by grasping end and removing it from water inlet of pump as shown. 2. Clean filter by flushing it with water on both sides. 3. Re-insert filter into water inlet of pump.NOTE: Cone side faces out. Filter Screen D25803 14- ENG STORAGE ENGINE Consult the Engine Owners Manual for the manufacturer's recommendations for storage. PUMP It is recommended that you follow these steps to protect the internal seals of the pressure washer when STORING THE UNIT FOR AN EXTENDED PERIOD and/or WHEN FREEZING TEMPERATURES ARE EXPECTED. NOTE: If storing the unit for more than 30 days *RV antifreeze needs to be run through the pump. This helps prevent damage within the pump head. RV antifreeze is not only added for winterizing, but for proper lubrication regardless of temperature or environment. *Windshield washer fluid may also be used. 1. Obtain a funnel, six ounces of RV antifreeze, and approximately 12 inches of garden hose with a male hose connector attached to one end. Use only RV antifreeze. Any other antifreeze is corrosive and can damage pump. 2. Disconnect spark plug wire. 3. Disconnect high pressure hose from pump and from spray gun. 4. Connect 12 inch length of hose to water inlet of pump. 5. Add RV antifreeze to hose as shown. 6. Pull engine starter rope slowly several times until antifreeze comes out of high pressure hose connection of pump. 7. Remove short hose from water inlet of pump. 8. Reconnect spark plug wire. 9. Drain all water from high pressure hose, coil it, and store it in cradle of the pressure washer handle. 10. Drain all water from spray gun and wand by holding spray gu...
Эта инструкция также подходит к моделям:Моечное оборудование - D25803-025-1 (383.96 kb)
Моечное оборудование - D25803-025-1 (383.96 kb)
Моечное оборудование - D25803-025-1 (383.96 kb)
Моечное оборудование - D25803-025-1 (383.96 kb)