Оценок - 4, средний балл: 4.3 ( )

Производитель: Graco Размер: 353.49 kb Название файла: Язык инструкции:

. If you use the Sandblaster Kit, see the Sandblaster Kit manual for detailed cleaning information. . See manual 308513 for chemical injector operation and service. 1. Check the oil level. NOTE: This pressure washer is equipped with a low-oil sensor that shuts the engine off if the oil level falls below a certain level. If the engine stops unexpectedly, check the oil and the fuel levels. Check the oil level each time you refuel. 2. Check the fuel level. WARNING FIRE HAZARD Do not refuel a hot engine. Refueling a hot engine could cause a fire. Use only fresh, clean, regular or unleaded gasoline. Close the fuel shutoff valve during refueling. 3. Turn on the water supply. CAUTION Never run the pressure washer dry. Costly damage to the pump will result. Always be sure the water supply is completely turned on before you run the pressure washer. 4. Trigger the gun until water sprays from the tip indicating that the air is purged from the system. 5. Open the fuel shutoff valve. Be sure the spark plug ignition cable is pushed firmly onto the spark plug. Put the engine switch in the ON position, and put the throttle in the RUN position. CAUTION Do not allow the pressure washer to idle for more than 10 minutes. Doing so may cause the recirculating water to overheat and seriously damage the pump. Turn off the pressure washer if it will not be spraying or cleaning at least every 10 minutes. If heated inlet water is used, reduce this time further. Do not operate the pressure washer with the inlet water screen removed. This screen helps keep abrasive sediment, which could clog the pump or damage the pump cylinders, out of the pump. Keep this screen clean. Do not pump caustic materials; such materials could corrode the pump components. 308524 5 Operation 6. Pull the starter rope to start the engine. Brace one foot on the pressure washer cart, and pull the starter rope out quickly. CAUTION Do not allow the starter rope to snap back against the engine. Let the rope recoil gently to prevent damage to the recoil mechanism. NOTE: For easier starting, have one person start the pressure washer while another person triggers the gun. If the engine is cold, start the engine with the choke completely closed. In cool weather, you might have to let the engine run with the choke closed for the first 10 to 30 seconds. In warm weather, open the choke completely as soon as the engine starts. If the engine is warm, start the engine with the choke completely open or partially closed. When the engine starts, open the choke completely. Trigger Safety Latch WARNING To reduce the risk of serious bodily injury, including fluid injection or splashing in the eyes or on the skin, always engage the trigger safety latch when you stop spraying even for a moment. In the engaged position, the trigger safety latch prevents the gun from being triggered accidentally by hand or if it is dropped or bumped. Be sure the latch is pushed fully down, or it will not prevent the gun from being triggered....

Скачать инструкцию

Чтобы скачать, введите 2 цифры: