Оценок - 3, средний балл: 3.7
(
)
)
|
Фрагмент инструкции
Use of pressure washer can create puddles and slippery surfaces. High pressure spray could cause you to fall if you are too close to the cleaning surface. WARNING • NEVER aim spray gun at people, animals or plants. • DO NOT allow CHILDREN to operate pressure washer. • NEVER repair high pressure hose. Replace it. • Keep high pressure hose connected to pump and spray gun while system is pressurized. • Squeeze trigger on spray gun to relieve trapped pressure, every time you stop engine. Engage trigger lock on spray gun. The high pressure stream of water that this equipment produces can pierce skin and its underlying tissues, leading to serious injury and possible amputation. Spray gun retains high pressure when pressure washer is shut down, which can cause injury. WARNING • When starting engine, pull cord slowly until resistance is felt and then pull rapidly to avoid kickback. • If engine starts and fails to continue to run or if increased resistance is felt during starting pull attempts, squeeze trigger on spray gun. Rapid retraction of starter cord (kickback) will pull hand and arm toward engine faster than you can let go. Broken bones, fractures, bruises or sprains could result. WARNING • Keep water spray away from electric wiring or fatal electric shock may result. Spray contact with electrical wiring can result in electrocution. WARNING 3 Section 1: Safety Rules • DO NOT touch hot surfaces. • Allow equipment to cool before touching. • The pressure washer must be at least 5 feet from structures having combustible walls and/or other combustible materials. • Keep at least 3 feet of clearance on all sides of pressure washer for adequate cooling, maintenance and servicing. • In the State of California a spark arrester is required by law (Section 4442 of the California Public Resources Code). Other states may have similar laws. Federal laws apply on federal lands. If you equip the muffler with a spark arrester, it must be 150°F (65°C). Severe burns can occur on contact. Combustible debris, such as leaves, grass, brush, etc. can catch fire. Running engines produce heat.Temperature of muffler and nearby areas can reach or exceed WARNING • DO NOT tamper with governed speed. • DO NOT operate pressure washer above rated pressure. Excessively high or low operating speeds increase risk of injury and damage to pressure washer. CAUTION A pressure washer produces a high pressure spray which increases risk of injury and damage to unit. CAUTION • DO NOT secure spray gun in open position. • DO NOT leave spray gun unattended while machine is running. • NEVER use a spray gun which does not have a trigger lock or trigger guard in place and in working order. • Always be certain spray gun, nozzles and accessories are correctly attached. CAUTION • DO NOT wear loose clothing, jewelry or anything that may Starter and other rotating parts can entangle hands, hair, clothing, or accessories. be caught in the starter or other rotating parts. • Tie up long hair and remove jewelry. WARNING maintained in effective working order. • DO NOT point spray gun at glass when using MAX (pin point) nozzle. • NEVER aim spray gun at plants. Improper treatment of pressure washer can damage it and shorten its life. CAUTION High pressure spray may damage fragile items including glass. • Always wear eye protection when using this equipment or in vicinity of where equipment is in use. High pressure spray can cause paint chips or other particles to become airborne. WARNING • If you have questions about intended use, ask dealer or contact Briggs & Stratton Power Products. • NEVER operate units with broken or missing parts, or without protective housing or covers. • DO NOT by–pass any safety device on this machine. • Before starting pressure washer in cold weather, check all parts of the equipment to be sure ice has not formed there. • NEVER move machine by pulling on high pressure hose. Use handle provided on unit. • Check fuel system for leaks or signs of deterioration, such as chafed or spongy hose, loose or missing clamps, or damaged tank or cap. Correct all defects before operating pressure Unintentional sparking can result in fire or electric shock. WARNING WHEN ADJUSTING OR MAKING REPAIRS TO YOUR PRESSURE WASHER • Disconnect spark plug wire from spark plug and place wire where it cannot contact spark plug. washer. • This equipment is designed to be used with Briggs & Stratton Power Products authorized parts ONLY. If equipment is used with parts that DO NOT comply with minimum specifications, user assumes all risks and liabilities. 4 5 KNOW YOUR PRESSURE WASHER Read this owner’s manual and safety rules before operating your pressure washer. Compare the illustrations with your pressure washer to familiarize yourself with the locations of various controls and adjustments. Save this manual for future reference. Accessory Tray — Provides convenient storage for standard and optional accessories, such as brushes, turbo wands, etc. Air Filter — Protects engin...
Эта инструкция также подходит к моделям:Моечное оборудование - 20228 (2.01 mb)