Оценок - 5, средний балл: 4.2
(
)
)
|
Фрагмент инструкции
GPM multiplied by PSI. Bypass Mode: In Bypass Mode, the pump is recirculating water because the trigger of the spray gun is not pulled. If unit is left in bypass mode for more than two (2) minutes, the water temperature can rise to a dangerous level and may damage internal components of the pump. Any damage to pump due to these causes will not be covered under warranty. DO NOT allow your unit to operate in bypass mode for more than two minutes at any time. Overheating of pump can cause damage to pump and will void the pump warranty. Thermal Relief Valve: In an effort to prevent extreme damage, pumps are equipped with a thermal relief valve. This valve will open when the temperature inside the pump rises too high. This valve will then release a gush of water in an effort to lower the temperature inside the pump. Immediately after this occurs, the valve will close. The thermal relief valve is part of the pump and is not visible to the user. Chemical Injection: Feeds cleaning agents into the pump to mix with the pressurized water and help in cleaning. Water Supply: All pressure washers must have a source of water. The minimum requirements for a water supply are 20 PSI and 5 gallons per minute. PRESSURE WASHER OPERATING FEATURES PRESSURE ADJUSTMENTS The pressure setting is preset at the factory to achieve op ti mum pres sure and cleaning. If you need to lower the pres sure, it can be accomplished by these meth ods. 1. Back away from the sur face to be cleaned. The further away you are, the less the pressure will be on the surface to be cleaned. 2. Change to a wider spray pattern nozzle. See How to Use Wand paragraph in this section- DO NOT attempt to increase pump pressure. A higher pressure setting than the factory set pressure may damage pump. A17914 10- ENG TO USE SPRAY WAND The nozzles for the spray wand are stored in nozzle holder on the panel assembly. Colors on the panel identify nozzle location and spray pattern. See chart to choose the correct nozzle for the job to be performed. CHANGING NOZZLES ON SPRAY WAND Risk of fluid injection. Do not direct discharge stream toward persons, unprotected skin, eyes or any pets or animals. Serious injury will occur. Flying objects could cause risk of serious injury. Do not attempt to change nozzles while pressure washer is running. Turn engine off before changing nozzles. 1. Pull quick- connect coupler back and insert nozzle. 2. Release quick- connect coupler and twist nozzle to make sure it is secure in coupler. Flying object could cause risk of serious injury. Ensure nozzle is completely inserted in quick-connect socket and quick-connect snap ring is fully engaged (forward) before squeezing gun trigger. Nozzle Color Red Yellow White Black Spray Pattern 0. 15. 40. low pressure Uses powerful pinpoint for very intense cleaning intense cleaning of small areas covers wide areas of cleaning applies cleaning solutions Surfaces * Metal or concrete DO NOT use on wood metal, concrete, or wood metal, concrete, woo...
Эта инструкция также подходит к моделям:Моечное оборудование - A17914-05-10-06 (1.42 mb)
Моечное оборудование - A17914-05-10-06 (1.42 mb)
Моечное оборудование - A17914-05-10-06 (1.42 mb)
Моечное оборудование - A17914-05-10-06 (1.42 mb)