Оценок - 2, средний балл: 4.5
(
)
)
|
Фрагмент инструкции
press the red stop button b. change the speed by raising or lowering the speed control lever c. press the green start button to restart the mixer. NOTE: The SP62P and SP80PL will automatically shut off if the speeds are changed while the mixer is in operation. Page 10 Cleaning Instructions Cleaning Instructions • Dilute detergent per supplier’s instruction. • DO NOT hose down or pressure wash any part of the mixer. • NEVER use a scrubber pad, steel wool, or abrasive material to clean the mixer. • NEVER use bleach (sodium hypochlorite) or bleach based cleaner. • ALWAYS remove the agitator after each batch. If not, the agitator can become stuck on the shaft and difficult to remove. The entire mixer, including removable parts, must be thoroughly cleaned and sanitized using the procedures identified by your local health department and the ServSafe Essentials published by the National Restaurant Association Educational Foundation (NRAEF). Visit for more details. It is extremely important to sanitize the mixer and to follow the instructions on the quaternary sanitizer container to ensure proper sanitation is achieved. ALWAYS DISCONNECT OR UNPLUG THE ELECTRICAL POWER FROM THE MIXER BEFORE CLEANING. RECOMMENDED CLEANING PART REQUIRED ACTION FREQUENCY Agitators Hand-wash using mild soap and water, rinse, dry, and sanitize. Clean after each use. Bowl Using a scrubber pad, mild soap and water, apply pressure to ensure the bowl is clean, rinse, dry, and sanitize. The bowl can also be placed in a dishwaser for cleaning. Clean after each use. Safety Guard For light-duty cleaning, fill bowl with mild soap and water. Scrub the safety guard with a brush, rinse, dry, and sanitize. Clean after each use. Rear Splash Guard Hand-wash using mild soap and water, or scrub with soft bristle brush, rinse, dry, and sanitize. Clean after each use. Bowl Cradle Hand-wash using mild soap and water, rinse, dry, and sanitize. Daily Planetary Shaft Wipe with clean damp cloth, dry, and sanitize. Apply a light quantity of Globe oil (mineral oil) to the planetary shaft after cleaning. Clean after each use. Exterior Hand-wash using mild soap and water, rinse, dry, and sanitize. DO NOT use a water hose! Daily Hub Interior Wipe with clean damp cloth, dry, and sanitize. Daily Page 11 Important Points Your new Globe mixer will provide years of uninterrupted service, but only if you do the following. Installation • Do not use an extension cord to connect electrical power. • Make sure all 3 Phase units (see data plate) run in the direction of the arrow on front of the machine. Operation • Turn off the mixer prior to changing speeds. • Follow the capacity chart on page 13, especially for mixing dough. • Use only first (1) speed for mixing dough. 2nd speed should never be used on 50% AR or lower with the exception of the SP60P. The SP60P requires a 50% reduction in batch size to mix in speed 2 with 50% AR doughs. • If the unit shuts off during mixing (overload protection trips), reduce the batch size. Maintenance • Add only 2 pumps of grease to the planetary grease fitting once a year. Recommended Maintenance PART REQUIRED ACTION FREQUENCY Planetary Ring Reapply grease (e.g. black axle grease). Inject grease (2 pumps only) into zerk fitting on the side of planetary. DO NOT over fill! Once a year. Bowl Slide Rods Apply Globe oil (mineral oil) on the bowl slide rods. Raise and lower the bowl to distribute the oil onto the...
Эта инструкция также подходит к моделям:Миксеры - SP20 (323.56 kb)
Миксеры - SP10 (323.56 kb)
Миксеры - SP25 (323.56 kb)
Миксеры - SP30 (323.56 kb)