Оценок - 3, средний балл: 3
(
)
)
|
Фрагмент инструкции
To the User You must read the instructions prior to installing and using the appliance and then retain them for future reference. 2 Instructions for use HOOD GB English BHC 90 BHC 110 Contents Installation, 4-5 Assembly Technical information, 6 Electrical connection Power cable Technical data Description, 7 Filtering version Ducting version Operation, 8 Controls Maintenance, 9 Cleaning the hood Cleaning the grease filters Replacing the charcoal filter Replacing the lamps Precautions and tips, 10 General safety Air vent Disposal GB 3 Installation GB Assembly Before proceeding with the assembly operations, remove the grease filters so that the hood is easier to handle (for the instructions see the paragraph “Cleaning the grease filters” in the chapter on “Maintenance”). Fixing to the wall 1) Draw a line on the wall along the vertical axis of the hob. Mark the 2 holes (A) to be made in the wall respecting the measurements indicated in the figure below. 2) Drill the holes (8 mm o) and fit the 2 screw anchors (provided). 3) Fix the metal bracket (B) to the wall with 2 screws using the 2 holes drilled. Use the 2 triangles cut into the bracket to position it exactly along the vertical axis of the hood. 4) Then hook the hood onto the metal bracket.Adjust the horizontal position by moving the hood to the right or left as required to align it with the wall units. 5) Once adjusted, finally fix the hood with a further 6 screws (D): Mark the 6 holes to be drilled on the wall, unhook the hood and drill the holes marked (8 mm diameter); then use the screw anchors and the screws provided for final fixing. FOR CORRECT FUNCTIONING, THE HOOD MUST BE FIXED USING ALL 6 SCREWS (D)! 6) For the hoods in filtering version, fit the reducer (E). Securing the decorative flue 1) Assemble the support bracket of the decorative flue and adjust the width with the 2 screws (F). Then, using the screw anchors and the screws (G), secure it to the ceiling in such a way that it is in line with the hood. 2) For the filtering version, the air vent grilles (H) must be positioned at the top. For the ducting version, turn the upper flue upside down so that the air vent grilles are at the bottom. 4 GB d) Make the electrical connection of the hood by means of the power cable (refer to the paragraph 3) Ducting version: “Electrical connection”). e) Lower the lower flue resting it on the hood. a) Connect the air vent of the hood to the air vent f) Check if the charcoal filter (P) has been hole using a flexible hose of 15 cm diameter. installed. If not yet installed, proceed by sliding Lock the flexible hose with hose clamps (hose the 2 filter clips into their seats and turn the and clamps not provided). filter upwards. b) Make the electrical connection of the hood by means of the power cable (refer to the paragraph “Electrical connection”). c) Fit the decorative flue resting it on the hood. Lift the upper flue up to the ceiling and secure it by means of the 2 screws (L). 4) Filtering version: a) Fit the baffle (M) to the upper flue using 4 flat- headed screws (N). Connect a flexible hose of...
Эта инструкция также подходит к моделям:Микроволновые печи - Cooker Hood BHC90 (1.19 mb)
Микроволновые печи - Cooker Hood BHC110 (1.19 mb)
Микроволновые печи - Cooker Hood BHC90 (1.19 mb)