Оценок - 4, средний балл: 3.8
(
)
)
|
Фрагмент инструкции
Position adjustment knobs facing out and tighten lower screws using a Phillips screwdriver. Figure 1 Figure 2 Rear extension tube Front extension tube Insert front and rear extension tubes, (B) and (C), into base frame as shown in figure 1. For the time being, set each tube at a height of approximately 4" and lock into place by tightening adjustment knob. (see figure 2). Adjustment knob Lower Phillips screw Place your drawing board/tabletop on a soft pad or carpet to avoid scratches with the best side facing down. Turn the assembled base frame (A) upside down and place on tabletop as shown in figure 3. Position the frame according to the dimensions in figure 4, depending on the size or your tabletop. Center from left to right. Place front guide tracks (F) under front leg extensions as shown. Use an awl or a 1/W' drill to start screw holes. Be careful not to drill all the way through tabletop. Attach rear extension brackets and front guide tracks to tabletop using /" Phillips screws (G). Figure 3 Rear extension brackets Since some screws are hard to reach, try spinning adjustment collar so that adjustment knob is out of your way. Once all screws are secure, return table to its upright position and adjust tube extensions until tabletop is at desired height and angle. ГМ -j w Front guide tracks u ? 3 5 Hint 6 Figure 4 Approx. 6"K- 2" 1" -H Approx. 6" ^ 2" For 30" x 42" Tabletop I 6!4" 6!4" ± 1" Approx. 3" k 1"' T For 24" x 36" Tabletop Approx. -H 3" ' 1" T .......0 ± 1". ^ 3W K- I -H 3!4" h? To Attach Pencil Ledge The pencil ledge (H) prevents materials from sliding off a tilted surface. Slotted connection allows for easy adjustment from flush to elevated position. Use an awl or a Vie" drill to start holes and attach using two screws (J) into front edge of tabletop. Flush Position % j Elevated Position To Fold Table Flat Loosen lower screws in front height adjustment collars (E) and spin collars until adjustment knobs face inward. Lift front edge of tabletop slightly to remove front extension tubes from front guide tracks and swing legs inward. Left leg should be folded first. When both front legs are folded into position, allow tabletop to drop downward. ©2007 ALVIN & COMPANY, INC. • P.O. Box 188, Windsor, CT 06095-0722 Phone: 860-243-8991 • Toll-Free: 800-444-2584 • Fax: 860-242-8037 • Toll-Free Fax: 800-777-2896 WWW.alvinCO.COm LIT-A7143 6/07...