Massage Head Tapping action Keep your head on the pillow until the soft tapping begins. Lifting your head from the pillow will result in incorrect determination of the shoulder position. • 3 Confirm that the shoulder position has been correctly determined according to the position of the soft tapping. When the shoulder position is incorrect, adjust the shoulder position while the soft tapping is in progress (for approximately 15 seconds), and use the POSITION button to move the massage heads up or down. A single press of the button will raise or lower the massage heads approximately 1/2 in. (1.2 cm). Too low Too high Correct position of the massage head (The point where the tapping action should be felt.) 4 Body scanning is completed when the tapping finishes. The legrest adjusts automatically so that the soles of the feet touch the footrest wells according to your estimated height based on the shoulder position. If the shoulder position is off drastically, turn the power off once, and repeat from Step 1 with shoulder firmly pressed against the backrest. • • • • To customize English 1 23456 1 Adjusting the intensity of massage for neck, shoulder, back, or lower back Intensity of the massage for current position can be adjusted by turning the dial on the controller. For Auto program Intensity Sensor will function. Movement of the massage head is adjusted automatically so the pressure of the massage head pressing the body stays same even if the curve or position of the body shifts. Current position that is getting massaged can be checked on the display. Intensity is displayed in 8 steps. Intensity will not change further even if you keep turning the dial when the intensity is set to maximum (8 bars are displayed) or minimum (1 bar is displayed). • • • • Caution Intensity might increase drastically when the intensity is increased in multiple steps. Always increase the intensity one step at a time, checking how it feels. For safety reasons, it is designed not to increase the intensity drastically even if the dial is turned rapidly. If you do not feel enough intensity even it is set to maximum, or you feel too much intensity even it is set to minimum: Massage heads will press on you stronger with back cushion taken off. Start at the first level and increase gradually as the intensity will be much greater without the cushion. Pressure of the massage heads will soften by placing a cloth or blanket between the back cushion and your body. • • 2 Massaging with stronger intensity Pressing the button enables to massage with a stronger intensity than just adjusting the intensity with the above procedure. It will be deactivated by pressing it again. Ultra Deep Mode is a mode that is set to massage with a stronger intensity than the setting of the Intensity Sensor. The display of the intensity mentioned above will not change even if this button is pressed. • Caution You may not feel the intensity has changed for the following reasons when it is increased by 1 step or “ULTRA DEEP” is pressed: • When the intensity was increased right when the operation has changed. • The feeling is different depending on the person or the position. English 4 Adjusting the reclining angle and legrest to massage in relaxing position To adjust the reclining angle and the legrest angle: Adjust by pressing button. To adjust the length of the legrest: Length of the legrest can be adjusted by pulling on the legrest slide lever and pushing with the soles of your feet. [Extendable length to approx. 4.7 in. (12 cm)] See pages 32 to 33 for description on how to adjust the reclining angle, the legrest, and the pillow. • 5 Setting the Off/On of the Lower Body or Hand/Arm air massage, or Off/On of the Leg Stretch Operation can be turned off/on by pressing button. (Off: button lamp off, On: button lamp on) 3 Massaging neck and shoulders only/Massaging back and lower back only Neck/Shoulder massage will be turned off by pressing button. Back/Lower Back massage will be turned off by pressing button. It will resume by pressing it again. You cannot turn off both Neck/Shoulder and Back/Lower Back at the same time. Lamp Off Display for the position will be turned off when you turn off that position. (Above display shows only neck and shoulder massage) • 6 Changing the intensity of the air massage for Lower Body or Hand/Arm Lower Body When performing an air massage on the lower body, ( will flash at this time) Adjust by pressing the button. Hand/Arm When performing an air massage on the hand and arm, ( will flash at this time) Adjust by pressing the button. Intensity of the Leg Stretch cannot be adjusted. Lamps for intensity will be off while performing the Leg Stretch. See pages 28 to 31 for effective method for usage and operations of the air massage and Leg Str...
)
