Оценок - 5, средний балл: 4.2
(
)
)
|
Фрагмент инструкции
The light will stay on as long as the battery is in the charger and the charger is plugged into a working outlet. It WILL NOT flash, go out or change to a different color when the charging cycle is complete. 8. Do not charge power pack in rain or in wet conditions. 9. Use only the batteries and charger supplied with your hedge trimmer or identical replacement parts. 10.Do not incinerate the batteries. They can explode in a fire. A small leakage of liquid from the battery cells may occur under extreme usage, charging or temperature conditions. This does not indicate a failure. However, if the outer seal is broken and this leakage gets on your skin: a. Wash quickly with soap and water. b. Neutralize with a mild acid such as lemon juice or vinegar. c. If the battery liquid gets in your eyes, flush them with clean water for a minimum of 10 minutes and seek immediate medical attention. MEDICAL NOTE: The liquid is a 25-35% solution of potassium hydroxide. 11.Do not open or mutilate the batteries. Released electrolyte is corrosive and may cause damage to the eyes or skin. It may be toxic if swallowed. 12.Exercise care when handling batteries in order not to short the battery with conducting materials such as rings, bracelets and keys. The battery or conductor may overheat and cause burns. SAVE THESE INSTRUCTIONS. 2 4 3 Switch Interrupteur Interruptor Lock out button Bouton de verrouillage Boton del seguro 0-15 5 6 BEFORE RETURNING THIS PRODUCT FOR ANY REASON PLEASE CALL 1-800-544-6986 IF YOU SHOULD EXPERIENCE APROBLEM WITH YOUR BLACK & DECKER PRODUCT, CALL 1-800-544-6986 BEFORE YOU CALL, HAVE THE FOLLOWING INFORMATION AVAILABLE, CATALOG No., TYPE No., AND DATE CODE (e.g. 0130M). IN MOST CASES, ABLACK & DECKER REPRESENTATIVE CAN RESOLVE YOUR PROBLEM OVER THE PHONE. IF YOU HAVE ASUGGESTION OR COMMENT, GIVE US ACALL. YOUR FEEDBACK IS VITALTO BLACK & DECKER. KEY IINFORMATIION YOU SHOULD KNOW:: • To operate the trimmer, the lock off button must be pushed forward. • The batteries in your power pack are not fully charged at the factory. Before attempting to charge them, thoroughly read all of the safety instructions. 1 SWITCH To turn the tool “ON”,slide the lock off button, shown in Figure 3, forward and, squeeze the trigger switch. Once the tool is running, you may release the lock off button. In order to keep the tool running you must continue to squeeze the trigger. To turn the tool “OFF”, simply release the trigger. TRIMMING INSTRUCTIONS 1. WORKING POSITION – Maintain proper footing and balance and do not overreach. Wear safety goggles, non-skid footwear and rubber gloves when trimming. Hold the tool firmly in both hands and turn the tool ON. Always hold the trimmer, as shown in the illustrations in this manual, with one hand on the switch handle and one hand on the bail handle. (Figure 4) Never hold the tool by the blade guard. 2. TRIMMING NEW GROWTH – (Figure 5) A wide, sweeping motion, feeding the blade teeth through the twigs is most effective. A slight downward tilt of the blade, in the direction of motion gives the best cutting. CAUTION Do not cut stems greater than 7/16” (12mm). Use the trimmer only for cutting normal shrubbery around houses and buildings. 3. LEVEL HEDGES (Figure 6) – To obtain exceptionally level hedges a piece of string can be stretched along the length of the hedge as a guide. 4. SIDE TRIMMING HEDGES (Figure 7) – Hold the trimmer as shown and begin at the bottom and sweep up. WARNING: TO GUARD AGAINST INJURY, OBSERVE THE FOLLOWING: • READ INSTRUCTION MANUAL BEFORE USING. • SAVE INSTRUCTION MANUAL. • KEEP HANDS AWAY FROM BLADES. • KEEP HANDS ON HANDLES. DON’T OVERREACH. • CAUTION – BLADE MAY COAST AFTER TURN OFF. • DO NOT USE UNDER WET CONDITIONS. MAINTENANCE A vinyl sheath is supplied with your trimmer. Slip the hedge trimmer into it, as shown in Figure 8. The cutting blades are made from high quality, hardened steel and with normal usage, they will not require resharpening. However, if you accidentally hit a wire fence, stones, glass or other hard objects, you may put a nick in the blade. There is no need to remove this nick as long as it does not interfere with the movement of the blade. If it does interfere, remove the battery and use a fine toothed file or sharpening stone to remove the nick. If you drop the trimmer, carefully inspect it for damage. If the blade is bent, housing cracked, or handles broken or if you see any other condition that may affect the trimmer’s operation contact your local Black & Decker Service Center for repairs before putting it back into use. Fertilizers and other garden chemicals contain agents which greatly accelerate the corrosion of metals. Do not store the tool on or adjacent to fertilizers or chemicals. With the battery removed, use only mild soap and a damp cloth to clean the tool. Never let any liquid get inside the tool; never immerse any part of the tool into a liquid. Prevent the blades from rusting by applying a film of light machine oil after cle...
Эта инструкция также подходит к моделям:Машинки для стрижки - CHT500 (680.4 kb)