Оценок - 0, средний балл: 0
(
)
)
|
Фрагмент инструкции
Note: Using setting 1 with the comb installed results in a ‘stubble look’. settings of beard trimming comb 1 2mm 2 4mm 3 6mm 4 8mm 5 10mm 6 12mm 7 14mm 8 16mm Setting Hair length after trimming 9 18mm 3 To trim in the most effective way, move the appliance slowly against the direction of hair growth. (Fig. 6) Do not move the appliance too fast. Make smooth and gentle movements and make sure the surface of the comb always stays in contact with the skin. 4 Regularly remove the comb to blow and/or shake out hair that has accumulated. You have to set the trimming length again after you have removed the comb! Beard trimming without comb Trimming without the comb results in a ver y shor t stubble beard. Be careful when you use the appliance without the comb, because the trimming attachment removes every hair it touches. 1 To remove the comb, press the hair length selector (1) and slide the comb upwards (2) (Fig. 7). Never pull at the flexible top of the comb. Always pull at the bottom par t. 2 Make well-controlled movements and touch your beard only lightly with the trimming attachment. Contouring scalp hair without comb Use the appliance without the comb to contour scalp hair edges. Be careful when you use the appliance without the comb, because the trimming attachment removes every hair it touches. 1 To remove the comb, press the hair length selector (1) and slide the comb upwards (2) (Fig. 7). Never pull at the flexible top of the comb. Always pull at the bottom par t. 2 Make well-controlled movements and touch the scalp hair contours only lightly with the trimming attachment. -To shape the contours round the ears, tilt the appliance in such a way that only one edge of the trimming attachment touches the hair ends. (Fig. 8) -To contour the nape hairline, hold the appliance with the teeth of the trimming attachment pointing towards the skin. (Fig. 9) -To contour the sideburns, hold the appliance with the teeth of the trimming attachment pointing towards the skin (Fig. 10). Defining beard, moustache and sideburns To remove the comb, press the hair length selector (1) and slide the comb upwards (2) (Fig. 7). Press the release button (1) and pull thetrimming attachment off the appliance (2). (Fig. 11) , Put the precision attachment on the appliance (‘click’). (Fig. 12) Hold the appliance upright when you use the precision attachment. (Fig. 13) 1 2 3 shaving shaving with the micro shaver attachment Before you use the micro shaver attachment, always check it for damage or wear. If the foil or cutter is damaged or worn, do not use the attachment as injury may occur. Replace the foil or the cutter before you use the attachment again. Put the micro shaver attachment on the appliance. (Fig. 14) 1 2 Gently press the micro shaver attachment onto the skin. Do not press too hard. 3 Shave along contoured edges to remove any stubble and to create a smooth, well-defined beard line. Cleaning Do not clean the appliance with water or a moist cloth. Never use scouring pads, abrasive cleaning agents or aggressive liquids such as alcohol, petrol or acetone to clean the appliance. Make sure the appliance is switched off and disconnected from the mains. 1 2 3 Remove the comb and/or attachment. Separate the top part of the micro shaver attachment from its body (Fig. 15). Avoid touching the shaving foil, as it is very delicate. Do not clean the foil with the brush, as this can cause damage. Blow and/or shake out any hair that has accumulated in the attachment. 4 5 6 Clean the outside and inside of the attachment with the brush supplied. (Fig. 16) Place the attachment back onto the appliance. Replacement Only replace worn or damaged attachments or combs with original Philips replacement attachments or combs, that are available from your dealer or an authorised Philips ser vice centre. If you have any difficulties obtaining replacement attachments or combs for your appliance, contact the Philips Consumer Care Centre in your countr y or consult the worldwide guarantee leaflet. Environment -Do not throw away the appliance with the normal household waste at the end of its life, but hand it in at an official collection point for recycling. By doing this, you help to preser ve the environment (Fig. 17). -The built-in rechargeable batter y contains substances that may pollute the environment. Always remove the batter y before you discard and hand in the appliance at an official collection point. Dispose of the batter y at an official collection point for batteries. If you have trouble removing the batter y, you can also take the appliance to a Philips ser vice centre.The staff of this centre will remove the batter y for you and wil...
Эта инструкция также подходит к моделям:Машинки для стрижки - QG3030/10 (684.28 kb)