Оценок - 3, средний балл: 4
(
)
)
|
Фрагмент инструкции
(Fig. 5) LOGAN* GRAPHIC PRODUCTS, INC. Tools for Art-Tools for Life Logan Graphic Products Inc., 1100 Brown Street, Wauconda, IL 60084 847-526-551 5 2 Instruction Manual TOTAL TRIMMER Model T300 &T360 Operation 1. Raise cutting bar using lifter arm or raise to full open position. (Fig. 6) 2. Slide material onto board and against squaring arm. (Fig. 7) 3. Adjust Stop to desired dimension. (Fig. 8) 4. Lower Cutting Bar 5. Slide Cutting Head beyond end of material. 6. Pivot blade down fully until it locks. (Fig. 9) 7. Place hand on to cutting handle & pull cutting head down through material until head reaches support bar. (Fig 10) 8. Upon contact with support bar, the blade holder will automatically release to safety position. (Fig. 11) LOGAN' GRAPHIC PRODUCTS, INC. - Tools for Art-Tools for ufe Logan Graphic Products Inc., 1100 Brown Street, Wauconda, IL 60084 847-526-551 5 3 Instruction Manual TOTAL TRIMMER Model T300 &T360 Maintenance and Adjustment Cutting Head Bearings If cutting head is loose or wobbling, tighten three adjustment screws to eliminate the play and improve cut accuracy. (Fig. 12) Resquare Squaring Arm 1. Place a carpenter's square against cutting bar first. Slide against squaring arm and look for gaps between square and squaring arm. (Fig. 13) 2. Notice which way squaring arm would have to move to eliminate gap. 3. Remove squaring arm and locate two screws inside side slots. (Fig. 14) 4. To adjust, move each screw equal but opposite directions. Only adjust a small amount. DO NOT ADJUST TENSION SCREw - Single screw on opposite side 5. Retest squareness. LOGAN' GRAPHIC PRODUCTS, INC. - Tools for Art-Tools for Life Logan Graphic Products Inc., 1100 Brown Street, Wauconda, IL 60084 847-526-5515 4 L3326 1/10...
Эта инструкция также подходит к моделям:Машинки для стрижки - T360 (400.22 kb)