Оценок - 3, средний балл: 4
(
)
)
|
Фрагмент инструкции
B-a, b) You can record right away with the built-in microphone. 1 Insert a normal (TYPE I) tape with the side to start recording facing the cassette holder. 2 Press r REC. Recording starts. At the end of the tape, recording stops and the unit turns off automatically. To Press or slide Stop recording p STOP Pause recording PAUSE c in the direction of the arrow To release pause recording, release PAUSE c*. Review the portion Press and hold 0 REW/REVIEW just recorded during recording. Release the button at the point to start playback. * PAUSE c will be also automatically released when p STOP is pressed (stop-pause-release function). To monitor the sound Connect an earphone (not supplied) firmly to the EAR jack. Note Do not use a CrO2 (TYPE II) or metal (TYPE IV) tape, otherwise the sound may be distorted when you play back the tape, or the previous recording may not be erased completely. To prevent a tape from being accidentally recorded over (see Fig. B-c) Break out and remove the cassette tabs. To reuse the tape for recording, cover the tab hole with adhesive tape. Playing a Tape (see Fig. C) 1 Insert a cassette with the side to start playing facing the cassette holder. 2 Press ( PLAY then adjust the volume. There is a raised dot to show the direction to turn down volume beside VOL. At the end of the tape, playback stops and the unit turns off automatically. If you plug in headphones (not supplied) to the EAR jack, you will get monaural output from both left and right channels. To Stop playback/stop fast forward or rewind Pause playback Search forward during playback (CUE) Search backward during playback (REVIEW) Fast forward** Rewind** Start recording during playback * PAUSE c will be also automatically released when p STOP is pressed (stop-pause-release function). ** If you leave the unit after the tape has been wound or rewound, the batteries will be consumed rapidly. Be sure to depress p STOP. z Additional Information Precautions On power • Operate the unit only on 3V DC. For AC operation, use the AC power adaptor recommended for the unit. Do not use any other type (TCM-333 only). For battery operation, use two size R6 (AA) batteries. On the unit • Do not leave the unit in a location near heat sources, or in a place subject to direct sunlight, excessive dust or mechanical shock. • Should any solid object or liquid fall into the unit, remove the batteries or disconnect the AC power adaptor (TCM-333 only), and have the unit checked by qualified personnel before operating it any further. • Keep personal credit cards using magnetic coding or spring-wound watches etc. away from the unit to prevent possible damage from the magnet used for the speaker. • If the unit has not been used for a long time, set it in the playback mode and warm it up for a few minutes before inserting a tape. On tapes longer than 90 minutes We do not recommend the use of tapes longer than 90 minutes except for a long continuous recording or playback. They are very thin and tend to be stretched easily. If you have any questions or problems concerning your unit, please consult your nearest Sony dealer. Troubleshooting Should any problem persist after you have made these checks, consult your nearest Sony dealer. You cannot press r REC. m The tab on the tape has been removed. You cannot press ( PLAY. m The tape has reached the end. Rewind the tape. The unit does not operate. m The batteries have been inserted with incorrect polarity. m The batteries are weak. m PAUSE c is slid in the direction of the arrow. m The AC power adaptor or car battery cord is not firmly connected (TCM-333 only). m The batteries have been inserted, but simultaneously the AC power adaptor is connected and not to be done to the wall outlet (TCM-333 only). No sound comes from the speaker. m The earphone is plugged in. m The volume is turned down completely. The sound drops out or comes with excessive noise. m The volume is turned down completely. m The batteries are weak. m The heads are contaminated. See “Maintenance.” Recording cannot be made. m Connection is made incorrectly. m The batteries are weak. m The record / playback head is contaminated. Recording cannot be erased completely. m The erase head is contaminated. m Recording or erasing is being made using recorded CrO2 (TYPE II) or metal (TYPE IV) tape. Maintenance (see Fig. D) To clean the tape heads and path Wipe the heads, pinch rollers, and the capstans with a cotton swab moistened with alcohol every 10 hours of use. Built-in microphone About This Manual The instructions in this manual are for TCM-333 and TCM-323. Before you start reading, check your model number. TCM-333 is the model used for illustration purposes. Any differences in operation are clearly indicated in the text, for example, “TCM-333 only”. z Getting Started Preparing a Power Source Choose one of the following power sources. Dry Batteries (see Fig. A-a) Make sure that nothing is connected to the DC IN 3V jack (TCM-333 only). 1 Open the ba...