Оценок - , средний балл:
(
)
)
Производитель: Raymarine
Размер: 93.46 kb
Название файла: c211627f-3efa-4a5a-abfc-cc55f8b370fd.pdf
Язык инструкции:
Документ загружается, подождите пожалуйста
 |
Документ загружается, подождите пожалуйста
Фрагмент инструкции
In this case, proceed to 'Cutting the bracket'. • There are two alternative slots for the bracket in the back cover of the wheel drive (Slot 1 and Slot 2). • Locate the motor tube where: • a 55 mm (21/e in) hole can be cut in the bulkhead/pedestal (if required) • the seal and ring can be secured around the motor tube • there is sufficient space behind the mounting location to allow at least 10 mm (0.4 in) clearance around the motor (see diagram below) CAUTION: Mount the drive so the motor tube is as far as possible from the boat's compass to reduce the risk of deviation. 3. Use the template to mark the locations of the bracket and motor tube. Cutting the motor tube hole 1. Drill a small pilot hole at the center of the intended motor tube location so you can check there is sufficient clearance behind the mounting location. CAUTION: Before you cut the motor tube hole, check behind the intended location for any steering mechanisms, cables or obstructions. 2. Cut a 55 mm (2Vs in) diameter hole at the motor tube location and smooth any sharp edges. 3. Assemble the ring/seal onto the motor tube: • fit the metal ring first • then fit the rubber seal: the seal will self-center on the tube 4. Temporarily mount the wheel and drive onto the spindle, allowing the motor tube to pass through the hole. 5. Press the seal against the bulkhead/pedestal, orientate the seal as required, then mark the centers of its mounting holes. Cutting the bracket 1. With the wheel still in place, hold the bracket under the wheel drive so you can mark dimension A - the distance between the mounting surface and the rear edge of the wheel drive front cover Note: If the wheel is bent or not running true, dimension A will change. Measure the shortest distance. C 2. Use a hacksaw to cut the pin 10 mm (0.4 in) LONGER than dimension A. Remove any sharp edges with a file or sandpaper. 3. Position the bracket so the pin is in the middle of the relevant slot. Note: the center of the bracket pin should be 154 mm (6.1 in) from the center of the wheel spindle. 4. Mark the center of the bracket's mounting holes then remove the wheel and drive. Attaching the bracket and ring/seal 1. Drill 4 mm (5/32 in) diameter pilot holes for the bracket and ring/seal mounting screws. 2. Attach the bracket using three self tapping screws (No 10 x 3/4 in). Note: on fiber-glass surfaces you may need to replace the mounting screws with suitable nuts, bolts and washers. 3. Remove the ring/seal from the motor tube, then use three self tapping screws (No 10 x 3/4 in) to attach them to the mounting surface. Note: make sure the rubber seal is closest to the surface (i.e. with the metal ring on top). Final assembly 1. Attach the drive cable to the socket on the motor tube, then secure the cable so it is clear of any moving parts. 2. Fit the wheel and drive back onto the wheel spindle and fully tighten the wheel nut. 3. Route the cable to the control unit, bearing in mind the EMC guidelines in the ST4000+ Handbook. Document number: 84092-1 Bracket location E ^ 235 mm (9.3 in) A...