Оценок - 3, средний балл: 4.3 ( )

Производитель: Attwood Размер: 63.95 kb Название файла: Язык инструкции:

(See Figure 2). 2. Assemble gasket to base. Cover Screw Stainless Steel Lens Cover Telltale Post Housing Vertical Tab, Aligned with Boat Centerline Mounting Screw Base Base Tabs Gasket Butt-Joint Connectors 3/8" Hole, Aligned with Boat Centerline 3. Align hole beneath light base with the position you’ve marked for the wire clearance hole. Set the lamp toward the bow and align vertical tab with the boat centerline. 4. Use the light base as a template to mark locations for the mounting screw pilot holes (use 2 #10 stainless steel screws). CAUTION Position holes carefully on aluminum boats so that wires do not contact the hull. 5. Drill wire clearance hole and pilot holes for the mounting screws. MOUNTING INSTRUCTIONS 1. Be sure gasket is aligned with the base. 2. Insert two #10 stainless steel mounting screws through base and fasten base to the deck. Tighten until gasket seals to the deck. NOTE If area below the light will not be reachable after installation, attach a suitable length of 16-gauge red- and black-colored NON-POWERED wire that can be routed to an accessible area. Make connections according to WIRING INSTRUCTIONS below. 3. Feed the positive (red or gray) and negative (black) wires through the hole in base and lead them below deck. 4. Lower the housing onto the base. Seat the housing so the base tabs fit in the housing grooves and the base screw mount aligns with the housing screw hole. 5. Replace the stainless steel cover, then fasten it with the Phillips-head screw. WIRING INSTRUCTIONS The power supply must be 12-volt DC ONLY. Use crimp-type marine-grade connectors with suitable waterproof insulation. Protect all connections with suitable materials. NOTE Failure to make proper connections and fuse the light properly will void the product warranty. CAUTION Polarity is important. If wiring is mis-connected the LED light will not operate. 1. Connect wires to fused power source: (See Figure 3). • Connect the (-) black wire to the negative (-) wire from the 12-volt supply. • Connect the (+) gray or red wire along with proper fuse and switch to the positive (+) 12-volt supply. • Fuse must be 1-amp. 2. Note that navigation rules require sidelights to be operated separately from anchor lights. Use either two switches or a single switch with three positions for off/anchor/running. Figure 3 (pos) (neg)(pos) 12V DC 1-Amp Fuse Switch Green Red (Starboard) (Port) ATTWOOD LIMITED 10-YEAR WARRANTY Because of the longevity of Attwood’s LED lighting technology, Attwood offers a limited 10-year warranty on this LED lighting product. See Product Catalog or attwoodmarine.com for details. © 2007 Attwood Corporation 1016 N. Monroe Street, Lowell, MI 49331-0260 Figure 2 3 3 ® Series 3500 Feux de cote a DEL de 1 NM et 2NM en acier inoxydable Lumiere de proue bicolore a DEL : Paire de feux de cote a DEL : CONSERVEZ CES DIRECTIVES Formulaire n° 69425 Rev. A 07-04 Feux de cote de 1 NM (serie 3520 et 3530) Pour les bateaux mesurant jusqu’a 1...

Скачать инструкцию

Чтобы скачать, введите 2 цифры: