Оценок - 3, средний балл: 3.7 ( )

Производитель: Craftsman Размер: 220.94 kb Название файла: Язык инструкции:

INSTALLING THE REAR RAIL • Position rail so that the right hand edge extends A'_ WARNING: Front and rear rails must be carefully aligned to reduce the risk of kickback, which can cause serious injury. • From the carton, remove the rear rail and the following hardware: Right and left end caps for rear rail 2 screws (5/32-32 x 1/2 in.) for end caps Note: The square head bolts, washers, and hex nuts shown at the top of figure 3 should still be on the table saw. If you mistakenly removed them, put them back on the table. Do not tighten. • Carefully slide the rail onto the square head bolts. SQUAREHEAD BOLT HEXNUT FLAT WASHER Fig. 4 2-1/2 in. beyond the table extension. Note: Instructions are given from the operator's position in front of the saw. • Push the rail against table and tighten each hex nut with a 12 mm wrench. If the rail jams or does not slide easily over the bolts, re-align the table extensions according to the instructions in the table saw owner's manual. Note: Make sure there are no gaps between the rail and edge of table or extensions. • Put the end caps on the rail ends. Insert the screws and tighten with a phillips screwdriver. SCREW 4 INSTALLING THE FRONT RAIL • Locate the front rail and the following hardware: Right and left end caps for front rail 2 screws (5/32-32 x 1/2 in.) for end caps • Set aside the end caps and two screws until the switch has been installed. Note: The square head bolts, washers, and hex nuts shown at the bottom of figure 6 should still be on the table saw. If you mistakenly removed them, put them back on the table. Do not tighten. • The back of the rail has two slots. See Figure Carefully slide the upper slot over the bolts. (Bottom slot is for switch.) • Align the rail left to right -Match the 7-1/8 in. mark on the right scale to the right edge of the saw base (main table). See Figure 8. • Snug the rail against table. Finger-tighten each nut on the table and extensions. SCALE FRONTRAIL HEIGHT HANDWHEEL SQUAREHEAD RAILSLOT HEXNUT SWITCHSLOT Fig. 7 TABLETOP VIEWEDFROMABOVE TABLE SAWTABLE EXTENSION SCALE \. FRONTRAIL 7-1/8 in, MARKRIGHTSCALE Fig. 8 HEXNUT FLATWASHER Fig. 6 • Insert the two remaining pan head screws into holes in the fine adjustment knob bracket. • Attach the fine adjustment knob bracket to the bottom of the fence head on the right or the left side of the fence handle. Securely tighten the two screws. BRACKET SCREWS __ Fig. 9 MOUNTING THE SWITCH • Locate the switch assembly, The fasteners should still be attached. Note: If the fasteners were removed from the switch, see instructions in your table saw Owner's Manual for mounting the switch or refer to Figure 10. • Holding the switch to the front, insert and slide the two square nuts into the lower slot of the front rail. _I, WARNING: Place the switch out of the immediate work area to avoid accidentally turning it off during operation. • Slide the switch assembly to a convenient position, leaving ample clearance for the handwheel. Tighten secure...

Скачать инструкцию

Чтобы скачать, введите 2 цифры: