Оценок - 5, средний балл: 3.4
(
)
)
|
Фрагмент инструкции
Then, reinstall the power switch bracket (Figure 7). Install the right rewinder on the outside of the frame and connect the motor wire connector to the rear wire (Figure 8 & 9). Reinstall the rear cover. Reinstall the side covers. Reinstall the lever knob and screw. 4. 5. 6. 7. 8. 16 ¿RSüæUn 15. MAINTENANCE Cleaning the Body of the laminator 1. To clean the machine body, dampen a cloth with water only and gently wipe the machine clean. Removing Adhesive Build Up 1. Remove the film from the laminator. 2. Use a damp (water only) cloth and a rubber gum eraser to remove the adhesive on the Teflon (metal) and silicone rollers. NOTE: Rub firmly but do not scrub the rollers vigorously as this mav scratch the surface.Do not use sharp metal objects, steel wool, or abrasives, as these mav also damage the rollers. 16. TROUBLESHOOTING Problem Cause Solution Machine will not turn on: a. Power plug is not plugged in. b. Power switch is in “0” (Off) position. c. Tripped circuit breaker. d. Blown main power fuse. a. Plug the power cord into appropriate outlet. b. Put the power switch to the “I” (On) position. c. Reset the circuit breaker. d. Replace the fuse. There is power, but the rollers are not turning after the “RUN” button is pressed: a. Emergency switch (es) is (are) engaged. b. Safety cover is not closed. c. Paper guide is not installed correctly. d. Blown motor fuse. a. Disengage the emergency switch (es). b. Close the safety cover to active the safety switch. c. Properly install the paper guide so that the micro switch is activated. d. Replace the motor fuse. The unit is not heating up: a. The machine is in “COLD” mode. b. Set temperature is lower than the room temperature. a. Switch to “HOT’ mode. b. Raise the temperature according to the recommended film temperature. Curled lamination: a. Upward curl. b. Downward curl. a. Loosen the top roll film tension. b. Loosen the bottom roll film tension. Unclear lamination: a. The main roller temperatures are too low and/or lamination speed is too fast. a. Raise the roller temperatures and/or lower the lamination speed. 17 RSS, RSR, RSH Series 17. SPECIFICATIONS o n: CM o CM CD I M O HI O m O'! o CN ££) E . E § 8 05 X X LO g 2 18...
Эта инструкция также подходит к моделям:Ламинаторы - RSH Series (708.46 kb)
Ламинаторы - RSH-1650 (708.46 kb)
Ламинаторы - RSR Series (708.46 kb)
Ламинаторы - RSR-1050 (708.46 kb)