Оценок - 4, средний балл: 4.8
(
)
)
|
Фрагмент инструкции
The PLH4100 is designed for documents up to 10 inches wide. The PLH4150 is designed for documents up to 15 inches wide. This unit also includes a 1.5 hour AUTO-SHUTOFF function. IMPORTANT SAFETY INSTRUCTIONS Your safety as well as the safety of others is important to Banner American Products, Inc. In this manual and on the product are important safety instructions. PLEASE READ ALL SAFETY INSTRUCTIONS CAREFULLY BEFORE OPERATING. CAUTIONS Before using your laminator, be sure to observe the following precautions: 1. Do not touch or place anything on hot surfaces. Wait for unit to cool before moving or cleaning. 2. To prevent electric shock do not immerse in or operate near water or other liquids. 3. The use of other attachments is not recommended by the manufacturer in conjunction with the product. Use of other attachments may cause injury. 4. This product is not intended for any other use other than lamination. 5. For best results it is recommended that only Banner American Products’ laminating pouches be used. 6. Always unplug the unit when not in use to prevent accidents. The electrical outlet should be installed near the equipment and should be easily accessible. 7. Do not operate with a damaged power supply cord. 8. Keep loose clothing, fingers, hair, jewelry and other foreign objects away from laminating slot. OPERATING PROCEDURES Be sure that the machine is placed on a flat surface. Plug the power cord into a grounded AC outlet. To use your laminator follow these directions: To Cold laminate: 1. Push the switch to COLD position. The RED LIGHT will illuminate, and the unit is ready to cold laminate. 2. Prepare the item to COLD laminate according to instructions for cold laminate pouch. 3. Feed document to be COLD laminated into front of the unit. It will be pulled into the laminator. Banner American suggests using the pouch carrier. To Hot Laminate: 1. Push the slide switch to LAMINATE position. The temperature control knob will be available for adjustment, you can select suitable temperature by turning knob to laminate different pouch sizes. After approximately 3-5 minutes, the unit is warmed up and the GREEN READY light will illuminate and the unit is ready to laminate. Note: If you slide the switch from FOIL to LAMINATE position, make sure to wait and laminate after 15 minutes. 2. Take one pouch and peel apart the pouch. Insert the document into the laminating pouch. 3. Insert the pouch (closed end first) into the laminator until the rollers catch the pouch and start to feed automatically. 4. Remove the pouch from rear of the laminator after it has completely exited the laminator. To Hot Foil Laminate: 1. Push the slide switch to the FOIL position. After approximately 5 minutes, the GREEN READY light will illuminate, and the unit is ready to foil. 2. Lay out the foil paper on the document according to foil instructions. Insert the foiled item against the fold inside the carrier. (A paper carrier must be used for foiling). 3. Insert the carrier (closed end first) into the laminator unit until the rollers catch the carrier and start to feed automatically. 4. Remove the carrier from the rear of the laminator after it has completely exited the laminator. Leave the document inside the carrier for several seconds to cool before removing it. To Turn the Laminator Off: 1. Push the switch to OFF position when you are finished lam...
Эта инструкция также подходит к моделям:Ламинаторы - PLH4150 (472 kb)