Оценок - 2, средний балл: 3
(
)
)
|
Фрагмент инструкции
Do not use any other type of outlet. NOTE: This appliance has a polarized plug (one blade is wider than the other). As a safety feature, this plug fits in a polarized outlet only one way. If the plug does not fit into the outlet, reverse the plug and try again. If it still does not fit, contact a qualified electrician. Do not attempt to defeat this safety feature. IMPORTANT NOTES: To ensure continued, efficient performance by your can opener, keep the cutting blade clean. Can opener should be turned off for 1 minute after operating for 5 minutes. TO USE THE CAN OPENER 1. Raise lever, place can under the guide bar and against the geared wheel. (See diagram A to identify parts.) 2. Press down on lever to pierce lid of can (Diagram B). This automatically starts the cutting action. The can opener will continue to cut until the lid is completely severed from the can. 3. Grasp the can, then raise the lever to release the can. 4. Carefully slide the lid away from the magnet, using caution to avoid being injured by the sharp edge of the lid. TO USE THE KNIFE/SCISSORS SHARPENER 1. Turn the unit sideways so that the knife sharpener is to your right (Diagram C). 2. Press down lever. 3. Place blade lightly in either left or right groove. Draw knife slowly toward you with a slow, even motion. 4. Place blade in other groove and repeat 4 or 5 times, alternating from one groove to the other until desired sharpness is achieved. Can Opener Knife/Scissors Sharpener DIAGRAM C Scissors Slot DIAGRAM B 5. This Can Opener/Knife Sharpener can also be used for sharpening scissors. A larger groove at the side of the knife sharpener is designed especially for scissors. Place one blade of the scissors in the groove, and then draw it toward you slowly and evenly. Repeat with the other blade. SPECIAL ATTENTION: Blades to be sharpened should be clean. Do not sharpen knives that have serrated blades. USER MAINTENANCE INSTRUCTIONS This appliance requires little maintenance and contains no user serviceable parts. Do not try to fix it yourself. Refer it to qualified service personnel if servicing is needed. NEVER IMMERSE CAN OPENER IN WATER OR ANY OTHER LIQUID. UNPLUG AND ALLOW TO COOL BEFORE CLEANING. TO CLEAN: Unplug unit from electrical outlet. To remove lever, hold can opener facing you. Lift the lever upward and gently pull toward you. Wash lever in warm, soapy water and wipe outside surfaces of unit with a damp cloth. To replace the lever, hold the can opener facing you with the lever in the lifted position, and put the long pivot into the pivot hole. At the same time the guide bar will align with the slot on the lever. Be sure to push completely into pivot hole. Then let lever drop back onto top of can opener. If you do not push lever completely into hole, it will not drop back onto top of opener. TO STORE: Unplug can opener and store in its box or in a dry place. Store the cord loosely coiled; never wrap it tightly around the unit. Do not put any stress on cord where it enters the appliance as it may cause the cord to fray and possibly ...
Эта инструкция также подходит к моделям:Кухонная посуда - Kitchen Utensil (31.35 kb)