Оценок - 2, средний балл: 3
(
)
)
|
Фрагмент инструкции
9. Do not place an appliance on or near a hot gas flame, electric element or on a heated oven. Do not place on top of any other appliance. 10.Do not let the power cord of an appliance hang over the edge of a table or bench top or touch any hot surface. 11. For safety reasons and to avoid maintenance by unskilled persons, some appliances are ‘sealed’ using tamperproof screws. Such appliances should always be returned to the nearest Sunbeam Appointed Service Centre for adjustment or repair if required. 12. Do not operate any electrical appliance with a damaged cord or after the appliance has been dropped or damaged in any manner. If damage is suspected, return the appliance to the nearest Sunbeam Appointed Service Centre for examination, repair or adjustment. 13. For additional protection, Sunbeam recommend the use of a residual current device (RCD) with a tripping current not exceeding 30mA in the electrical circuit supplying power to your appliances. 14. Do not immerse the appliance in water or any other liquid unless recommended. Features of your Pedicure Foot Spa Control Dial Anti Splash Cover Massage Nodes Rollers 4 attachments – cleansing brush, pumice stone, massage and reflexology Control Panel Control Panel Storage compartment Pedicure centre Infra-red panel Using Your Pedicure Foot Spa 1. Ensure that the control dial is in the ‘O’ off position. 2. Place the product on a firm, level floor 3. Place a chair behind the unit and adjust its position until you can sit comfortably with your feet inside the appliance (without water). 4. Place a towel within easy reach to dry your feet afterwards. 5. Using a large jug, fill the foot spa with water. Do not fill above the maximum level indicated. 6. Do not use hot water as this will make your feet sweat. 7. Insert the plug into a 230-240 volt power outlet and turn on. 8. Sit in the chair and place your feet in the appliance. 9. Turn the switch to the setting you wish to use – Setting 1 – Massage, Heat & Infra-red heat When using this setting, the appliance will maintain the temperature of the water which you have added. It will not heat cold water. To increase the intensity of the massage, move your feet backwards and forwards over the rollers in the base of the appliance. If the rollers are not required simply remove and replace with the plain insets. Place the sole of your foot on the infra-red panel to soothe and ease aches and pains. This also helps with the absorption of any treatment creams. Setting 2 –Massage, Heat, Infra-red heat & Bubbles This setting will also make the water bubble for an invigorating treatment. Use all these features when feet are tired and sore. Setting 3 – Bubbles & Heat Using the Pedicure Centre Push one of the attachments onto the fitting on the pedicure centre. Press lightly with your foot to activate. Maintain pressure whilst moving the attachment over the sole of the foot. Use the Cleansing Brush attachment to gently cleanse the foot. Use the Pumice Stone attachment to rub away hard skin which will have been softened by the water. Use the Massage attachment to massage all over your foot. Use the Reflexology Attachment to massage a particular part of the foot. Lift your foot from the unit to stop it rotating. Lift the attachment straight up to remove it. 10. Do not use the product for more than 20 minutes. 11. When you have finished using the appliance, return the switch to the ‘O’ off position and remove your feet from the unit and dry thoroughly. 12. Turn off power outlet and remove plug. 13. Discard the water. Care and Cleaning 1. Turn the control dial to the ‘O’ off position 2. Turn the power off and remove the plug from the power outlet. 3. Rinse the inside of the appliance with warm water. 4. Do not immerse the appliance in water or any other liquid 5. The inside of the appliance, the attachments and the exterior walls can be wiped over with a cloth dampened in water and a mild detergent. Then rinse and dry 6. The attachments can be washed in a mild detergent. Dry thoroughly before using again. Store in the storage compartment Help Line If you have any additional questions about using the Pedicure Foot Spa please call the Sunbeam help line in Australia on 1 800 025 059. In New Zealand please call 09 912 0747. Sunbeam is a registered trademark. Made in China. Due to minor changes in design or otherwise, the product may differ from the one shown in this leaflet. Approved by the appropriate Electrical Regulatory Authorities. Backed by Sunbeam‘s 12 Month Replacement Guarantee and National Service Network. © Copyright. SUNBEAM CORPORATION LIMITED 2003. (INCORPORATED IN N.S.W.) A.C.N. 000 006 771 Sunbeam Corporation is a division of GUD Holdings Ltd. For more information or advice on this or any other Sunbeam appliance, visit or contact the Sunbeam Consumer Service Line. Australia 1800 025 059 New Zealand (09) 912 0747. Therapeutics Consumer Hotline Australia 1800 025 059 New Zealand (09) 912 0747 www.sunbeam...