Войти:
Оценок - 2, средний балл: 3.5 ( )

Инструкция по эксплуатации Alen, модель C360

Производитель: Alen
Размер: 473.45 kb
Название файла: c5e678bf-4c93-4f46-ba3a-a6c0d5022e5d.pdf
Язык инструкции:en
Перейти к скачиванию



Фрагмент инструкции


SAFETY RULES …………………………………………………………...2 2. NAME OF PARTS ………………………………………………………...3 3. ACCESSORIES …………………………………………………………….3 4. OPERATION PANEL OF THE AIR CONDITIONER ……………..…… 4-5 5. OPERATION AND INDICATION SECTIONS OF REMOTE CONTROLLER ……………………………………………….………..6-7 6. OPERATION METHOD………………………………………….…..… 8-10 7. KEY-OPERATING INSTRUCTION FOR THE AIR CONDITIONER..…………………………………………………..…. 11-13 8. INSTALLATION ..………………………………………………......… 13-15 9. MAINTENANCE …………………………………………………………15 10.TROUBLE SHOOTING ..…………………………………………………16 2 SAFETY RULES 1. Do not connect unit to any AC socket in disrepair. 2. Do not use in the following locations: A: Next to source of fire B: An area where oil is likely to splash. C: An area exposed to direct sunlight. D: An area where water is likely to splash. E: Near a bath, a shower or a swimming pool. 3. Never insert your fingers or any foreign objects into the air outlet. Take special care to warn children of these dangers. 4. Always store the unit upright in order to maintain the compressor in a proper condition. 5. Be sure to unplug the unit before cleaning. 6. The heater must not be located immediately below a socket outlet. 7. If the appliance is covered, there is a risk of overheating. 8. If the plug or electrical cord is damaged, it must be replaced by a repair shop appointed by the manufacturer, because special purpose tools are required. NOTE: The air-conditioner can be connected only a supply system impedance of no more than 0.4582 ohm. If unsure, please consult your supply authority for system impedance information. 3 NAME OF PARTS REAR COVER AIR INLET REMOTE CONTROLLER CASTER AIR OUTLET OPERATION PANEL POWER CORD WATER PUMP DRAIN HOSE FRONT COVER AIR INLET CONTINUOUS DRAIN HOSE AIR OUTLET AIR INLET SIDE VIEW REAR VIEW FRONT VIEW Fig.1 ACCESSORIES PARTS PARTS NAMEQUANTITY DUCT ASSEMBLY 1 INSTALLTION PLATE WATER PUMP DRAIN HOSE1 Fig.2 Check all the accessories are included in the package and please refer to the installation instructions for their usage. 4 OPERATION PANEL OF THE AIR CONDITIONER i. A model display indicators (with electricity heating): ly Set ee light Fig.3 ii. A model display indicators (only cooling): light Set Fig.4 5 . B model display indicators : F Receiver Fig.5 DISPLAY: Auto mode indicate Cooling mode indicate Fan speed Heating mode indicate mode indicate Timer indicate Digital display Swing indicate Locked indicate F Fig.6 Note: 1.The AutoCoolingHeatingDry mode indicators will not display in the Fan mode. 2.The relevant display light according the set content by remote controller. 3.Air conditioner does not operate normally when set temperature indicator displaies unnormally, please contact with the distributor for service. <> 6 OPERATION OF THE REMOTE CONTROL Display Screen For setting display Sleep Button For setting sleep function. Time setting Button Press this button to set timer or the clock time. Hour Button Press this button to change hour setting. Reset Button Reset remote control to the original status. ON/OFF Button Press this button to start / stop air conditioner. Minute Button Press this button to change the minute setting. Airflow sweep Button For changing louver position. Timer selection Button Selecting procedures: On timer > Off timer> Program control >Timer cancelled >On timer AUH Button To change the condition of starting auxiliary electric heater when air conditioner in HEAT mode. Mode selection Button For selecting AUTO HEAT COOL DRY SWEEP Fan speed button For selecting indoor fan speed: Auto Medium High Low AUTTemp Adjustment Buttons Press “Ў” to decrease temp. Press “^” to increase temp. MODE SLEEP ON/OFF TEMPERATURE FAN SPEED AUH FAN SWEEP TIME TIMER HOUR MINUTE RESET AUTO SET TEMP PROGRAM Remarks: Temperature can be set between60~89. 7 Remote Controller Display Sleep Mode Display Displayed when Pressing “SLEEP” button the unit will enter into sleeping operation. Air refresh Display (Not available) AUH Display It appears when pressing the AUH key is add in HEAT mode. Signal Emission Symbol It appears when control signal is emitted. Display displayed when temp is displayed. Time Display Displays the time of clock or timing ON/OFF. AUTSET TEMP PROGRAM Wind Speed Selection Display High speed Medium speed Auto Low speed AUTOperating Mode Selection Display Timer setting Display PROGRAM ON timer OFF timer Program Timer canceled AUTO COOL DRY HEAT FAN Instructions for the remote controller • The remote controller uses two AAA alkaline battrries. Under normal condition, the batteries last for about 6 months. Please use two new batteries of similar type (pay attention to the poles in installing). After replacing the batteries, please use a point object (such as pen tip) to press “Reset” button. • The effective control distance of the remote controller is about 8 yards. • When using the remote controller, please point the signal emitter towards the air conditioner rec...

Эта инструкция также подходит к моделям:
Кондиционеры - C475A (473.45 kb)

Напишите ваш отзыв об устройстве



Текст отзыва
Ваше имя:
Введите две цифры:
capcha





Категории