Оценок - 1, средний балл: 5 ( )

Производитель: Haier Размер: 351.71 kb Название файла: 5d40cab8-ad15-4d9a-9430-4bfcaf922923.pdf Язык инструкции:

Dometic cannot assist in sizing an inverter/generator as the manufacturer of that item is best suited for that task. Damage to a unit caused by an inadequate inverter/generator is not covered under warranty. Safe Operation of Carry-On 1. Use cord labled with LCDI or AFCI to connect to power source (see warning). 2. Using the Carry-On is not recommended while the boat is under way. 3. Prevent accidents or damage to Carry-On. Always carry or move unit using the handles. Unplug at receptacle and Carry-On control panel prior to moving. 4. Do not disassemble Carry-On. 5. Be certain the Carry-On has been properly installed according to the Installation Instructions. 6. Physical and electrical conditions vary greatly from location to location. (a.) Be sure the electrical service is adequate and equipped with a circuit breaker (15 amps minimum for 115V units, 10 amps minimum for 220V units). (b.) Use a three-prong (grounded) power cord rated at 15 amps minimum for 115V units or 10 amps minimum for 220V units, with a length no longer than needed to reach from the installed Carry-On to a grounded, 3-wire receptacle on your boat, or to a suitable grounded dockside outlet (order part number LCDI25). L-2245 4 . .....English (c.) DANGER - SHOCK HAZARD! Do not, under any circumstances, cut or remove the grounding prong from the end of your power cord. Your Carry-On must be used with a three-prong grounding power cord and connected to a properly grounded and polarized three prong receptacle. DO NOT USE AN ADAPTOR PLUG, OR A TWO BLADE ADAPTOR PLUG THAT BYPASSES THE GROUNDING IN ANY WAY!!! (d.) It is always desirable to have your on-board or shoreside receptacle protected by a time delay fuse or circuit breaker. 7. If the Carry-On operation is interrupted (turned off, plug pulled out, thunderstorm, etc., accidentally or otherwise) after operation in the COOL mode, WAIT 3 MINUTES BEFORE RESTARTING. This allows pressure inside the compressor to equalize. Consequences of attempted restart within the 3 minute period may be a tripped circuit breaker or blown fuse. In this case, turn Carry-On to “OFF”, reset breaker (or replace fuse), wait 3 minutes, then restart. 8. If the Carry-On has been stored in any position other than upright within 10 degrees of level, then, after installing, wait 30 minutes to allow compressor oil to settle to the bottom of the compressor. Otherwise permanent damage may occur, voiding the warranty. Wiring Diagram L-2245 5 . .....English Carry-On 7000 Portable Air Conditioners • Installation Alternate Batten Pocket Batten Pocket Batten Figure 2. Close-up of Batten and Batten Pockets Figure 1. The Carry-On positioned in the boat hatch with the Hatch Bag in place. See inset Figure 2. 1. Place in open hatch as shown. (See Figure 5.) Adjust Carry-On so that the hatch pad protects and insulates the hatch and the Carry-On unit. Make sure that movement of Carry-On is stifled due to wedging action of the hatch pad as it presses against hatch edge. NOTE: Carry-On may be further secured using the D-ring type "tie downs". 2. Place hatch bag over Carry-On in grooves provided. Do not allow hatch bag to cover air intake vents or condensate drain. (See Fig. 1.) 3. Adjust the hatch bag over the hatch cover and hatch opening. The hatch bag is designed to keep outside air from entering the hatch while the Carry-On is in use. The fit should be as snug as possible. Use the battens provided to form the deckframe. Slide the battens into the pockets provided. Note that there is an alternative set of batten pockets for use with a smaller hatch. Should you decide to Figures 3a & 3b. These figures show proper and improper positioning and leveling of the Carry-On unit in the boat hatch. It is very important that the Carry-On be level. 3a. Proper Positioning In Hatch 3b. Improper Positioning In Hatch 6 L-2245 . .....English use the alternative batten pockets, you must cut the battens to size. A more weathertight seal can be achieved if you adapt the hatch bag to your boat using a Velcro® brand fastener, or snaps. Consult your marine dealer or canvas shop if you need help. 4. Level unit with adjustable cam and leg. Adjust the leg until the indicator bubble is away from the side of the level. It is not necessary to exactly center the bubble. If your hatch location is such that the Carry-On cannot be leveled with the leg fully extended, you must provide an additional means of support to allow the degree of leveling described. Under no circumstances should the Carry-On be operated more than 10 degrees off level, since this could cause loss of proper lubrication to internal parts and void the warranty (See Figures 3a & 3b). 5. A condensate drain is located under the unit (See Figure 4) in a position such that water...

Скачать инструкцию

Чтобы скачать, введите 2 цифры: