The appliance will shed water if you fail to do so. You have now removed all the excess water from the system and can turn the appliance back on and use as normal. Instructions for Use Ways of releasing air outdoors o Connect the diffusion duct to the hot-air expulsion duct. o Open the window slightly and feed the diffusion duct through the gap. o Close the window as much as possible and secure it in place using the suction pad provided. Temporary installation Permanent installation The appliance can be installed on a permanent basis using window/wall Optional Accessory, reference S1 RKZ 06009, available from your supplier. o A hole must be made in the wall and the wall accessory fitted in order to expel hot air. o Store the diffusion duct away and connect the air expulsion duct to the accessory. o Only the transparent end section of the accessory is used when air is to be expelled through a window on a permanent basis. A 10.5- cm. diameter hole must be made in the glass in order to fit the accessory. 24 - 38 cm. N.B. • Do not extend the hot-air expulsion duct more than necessary (maximum length: 140 cm.). • There must be a distance of at least 70 cm. between the floor and the end of the duct. • Do not bend the duct too sharply when positioning it. This can impede proper hot-air expulsion, which may reduce cooling efficiency. 23 24 Heating At this setting the appliance heats the air in the room and filters it at the same time. o Put the expulsion duct in storage position. o Set to heating function. Warning! Do not obstruct the air inlets and outlets on your appliance. o Set the thermostat to the desired temperature. Once this temperature has been reached, the appliance will turn itself off automatically. It will come back on again when the temperature falls 2-3°C. Dehumidification When set to , the appliance removes humidity from the atmosphere. It does not, however, control the temperature. o Turn drainage stopcock 90° in an anti-clockwise direction. o Remove stopcock plug and insert drainage pipe. stored in the main filter compartment. o Place a bowl at the drainage pipe outlet to collect the condensed water in. o Put the air extraction duct in storage position. o Set control knob to dehumidification position . o The amount of water removed from the air can reach as much as 30 liters/24 hours, depending on atmospheric conditions. Air purification Warning! • Do not forget to put the plug back in place on the drainage stopcock and to turn the stopcock 90° in a clockwise direction before setting the appliance to the temperature control setting. The appliance will shed water should you fail to do so. • Always remember that in order for the dehumidification function to work properly, ambient temperature must be at least 18°C. The air inside a room is circulated through a set of purifying filters when the appliance is set to this function. o The appliance comes with a main filter with a double active purifying filter. This special filter is for: -Smells and smoke. -Pollen, bacteria and dust. o Put the air expulsion duct in storage position. o Set to purification function . o When the appliance or the model is fitted with optional filters, we recommend you leave the optional filters in position regardless of the desired function setting (cooling, dehumidification, air purification). The appliance purifies the air more efficiently in this way. 26 o Clean the air filter. o Then clean the casing and grilles if necessary. Cleaning o The appliance is equipped with a main air filter. This filter must be removed, washed with water, dried and refitted on a regular basis. o The set of purifying filters reference S1 RKZ 09013, must be replaced with a new set every year in order to work efficiently. Contact your supplier. o The filters must be fitted as shown in figures. o Place only one set of filters onto fixture to avoid affecting cooling efficiency. o The appliance can be cleaned with a cloth or sponge, warm water and mild detergent. o Never use hot water (more than 40°C), bleach, petrol-based products, acids or brushes when cleaning your appliance. Prevent water entering the appliance. o Do not clean your appliance with a hose. Cleaning and Maintenance Prior to use at change of season Technical Service / Warranty Technical service Warranty Should your appliance fail to work properly and all the instructions for use and installation (especially the section headed "Requirements....") have been carefully observed, then remember that our Technical Service Network is at your full disposal. When contacting the Technical Service, quote the model code (E-NR) and the appliance’s factory number (FD). This information can be found on characteristics plate. The conditions of warranty depend on the relevant Supplier in a particular country. Contact the establishment where you purchased your appliance for more information and quote the appliance model and factory number. The receipt of purchase for the appliance must be produced pr...