Оценок - 0, средний балл: 0
(
)
)
|
Фрагмент инструкции
The cold circuit needs thisAfter turning your appliance off, wait at least 3 minutes before turning it back on again. The cold circuit needs thisAfter turning your appliance off, wait at least 3 minutes before turning it back on again. The cold circuit needs thisAfter turning your appliance off, wait at least 3 minutes before turning it back on again. The cold circuit needs this amount of time in order to reset. amount of time in order to reset.amount of time in order to reset.amount of time in order to reset.amount of time in order to reset.amount of time in order to reset. MOBILITY The appliance is fitted with wheels which allow it to be moved about. Should it be necessary to tilt the appliance when moving it, the internal water tank will have to be emptied beforehand with the help of the drain pipe (fig.A,3) placed onto the drain cock (fig.A,7) at the bottom of the appliance, as shown in (fig K). Once the appliance has been put back into the upright position leave it to stand for a few minutes before switching it back on. Attention! Attention!Attention!Attention!Attention!Attention! Take special care when moving this appliance. The base is fitted with a drain outlet pipe that may break off if Take special care when moving this appliance. The base is fitted with a drain outlet pipe that may break off ifTake special care when moving this appliance. The base is fitted with a drain outlet pipe that may break off ifTake special care when moving this appliance. The base is fitted with a drain outlet pipe that may break off ifTake special care when moving this appliance. The base is fitted with a drain outlet pipe that may break off ifTake special care when moving this appliance. The base is fitted with a drain outlet pipe that may break off ifknocked. knocked.knocked.knocked.knocked.knocked. INSTRUCTIONS FOR USE INSTALLATION A) Hinge or sash windows (fig. L) -Connect the diffuser sleeve to the warm air expulsion pipe. -Open the window slightly and place the sleeve between the jamb and the frame. -Close the window as far as possible and hold it with the suction cup supplied. B) Sliding windows (fig. M) -Connect the diffuser sleeve to the warm air expulsion pipe. -Fit the sliding window installation accessory using the side of the window frame to support it and then adjust it to the right height. -Close the window as far as possible and insert the diffuser sleeve through the outlet hole. C) Fixed installation -Use the optional window/wall sleeving accessory which can be purchased from your usual supplier of electrical appliances. (Ref.: B1RKZ06009) -It will be necessary to make a hole in the wall to accommodate the hot air pipe sleeve (Fig. I). -Take the diffuser sleeve off and connect the warm air expulsion pipe to the accessory. AA4000/4020/8000 11 13/9/04, 10:26 -When the installation goes through a window, you only need to use the transparent end piece of the accessory. Under these circumstances it will be necessary to cut a hole in the glass, 10....
Эта инструкция также подходит к моделям:Кондиционеры - AA4000/02 (1.05 mb)
Кондиционеры - AA4000/03 (1.05 mb)
Кондиционеры - AA4000/04 (1.05 mb)
Кондиционеры - AA4000/05 (1.05 mb)