Оценок - 4, средний балл: 3.8 ( )

Производитель: Admiral Размер: 5.53 mb Название файла: Язык инструкции:

5. When outdoor temperature is cool enough, use HIGH or LOW FAN only. This circulates indoor air, providing some cooling comfort, and utilizes less electricity than when operating on a cooling setting. 2/5"Screws (8) Top Channel(1) factory installed Side Curtain RH(1) Side Curtain LH(1) Installation Hardware 3/4"Screws (12) Seal(1) Foam(1) Tools Needed for Window Installation Screw drivers: Both Philips and flat head Power drill: 1/8 inch diameter drill bit Pencil Measuring tape Scissors Carpenters level L Bracket(2) Side Bracket(2) Fig.1 To avoid installation/operating difficulties, read the instructions thoroughly. NOTE: Save the shipping carton and packing materials for future storage or transport of the unit. Please check the contents of the hardware kit against the corresponding model check list, prior to installation of the unit. See lists below.(Fig.1) CAUTION! ! Your Room Air Conditioner was designed for easy installation in a single or double-hung window. NOTE: This unit is NOT designed for vertical (slider type) windows. NOTE: Surplus screw(s) for spare use. 5 Tips before installation Your Room Air Conditioner unit is designed to be highly efficient and save energy. Follow these recommendations for greater efficiency. 1. Select the thermostat setting that suits your comfort needs and leave the thermostat at that chosen setting. 2. The air filter is very efficient in removing airborne particles. Keep the air filter clean. Normally, the filter should be cleaned once a month. More frequent cleaning may be necessary depending on outdoor and indoor air quality. 3. Use drapes, curtains, or shades to keep direct sunlight from heating your room, but DO NOT obstruct the air conditioner. Allow air to circulate around the unit without obstructions. 4. Start your air conditioner before outdoor air becomes hot and uncomfortable. This avoids an initial period of discomfort while the unit is cooling off the room. 5. When outdoor temperature is cool enough, use HIGH or LOW FAN only. This circulates indoor air, providing some cooling comfort, and utilizes less electricity than when operating on a cooling setting. 2/5"Screws (8) Top Channel(1) factory installed Side Curtain RH(1) Side Curtain LH(1) Installation Hardware 3/4"Screws (12) Seal(1) Foam(1) Tools Needed for Window Installation Screw drivers: Both Philips and flat head Power drill: 1/8 inch diameter drill bit Pencil Measuring tape Scissors Carpenters level L Bracket(2) Side Bracket(2) Fig.1 To avoid installation/operating difficulties, read the instructions thoroughly. NOTE: Save the shipping carton and packing materials for future storage or transport of the unit. Please check the contents of the hardware kit against the corresponding model check list, prior to installation of the unit. See lists below.(Fig.1) CAUTION! ! Your Room Air Conditioner was designed for easy installation in a single or double-hung window. NOTE: This unit is NOT designed for vertical (slider type) windows. NOTE: Surplus screw(s) for spare use. Installation instructions F. Your unit was designed to evaporate condensation under normal conditions. However, under extreme humidity conditions, excess condensation may cause base pan to overflow to the outside. The unit should be installed where condensation run-off cannot drip on pedestrians or neighboring properties. Awning Window opening requirements(see table below) Side obstruction Ground Fence, wall, or other obstacle. 12" Min. 30" Min. 20" Min. 20" Min. CAUTION! ! Because the compressor is located on the controls side of the unit (right side), this side will be heavier and more awkward to manipulate. Inadequate support on the control side of the unit can result in personal injury and damage to your unit and property. There...

Скачать инструкцию

Чтобы скачать, введите 2 цифры: