Оценок - 3, средний балл: 3.7 ( )

Производитель: Admiral Размер: 3.85 mb Название файла: Язык инструкции:

To test your power supply cord: 1. Plug power supply cord into a grounded 3-prong outlet. 2. Press RESET. 3. Press TEST (listen for click; Reset button will trip and pop out). 4. Press and release RESET (listen for click; Reset button will latch and remain in).The power supply cord is ready for operation. NOTES: • The Reset button must be pushed in for proper operation. • The power supply cord must be replaced if it fails to trip when the test button is pressed or fails to rest. • Do not use the power supply cord as as an off/on switch. The power supply cord is designed as a protective device. • A damaged power supply cord must be replaced with a new power supply cord obtained from the product manufacturer and must not be repaired. • The power supply cord contains no use serviceable parts. Opening the tamper-resistant case voids all warranty and performance claims. INSTALLATION INSTRUCTIONS Unpack the Air Conditioner EXCESSIVE WEIGHT HAZARD Use two or more people to move and install air conditioner. Failure to do so can result in back or other injury. Remove packaging materials • Remove and properly dispose of packaging materials. Remove tape and glue residue from surfaces before turning on the air conditioner. Rub a small amount of liquid dish soap over the adhesive with your fingers. Wipe with warm water and dry. • Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners to remove tape or glue. These products can damage the surface of your air conditioner. • Handle air conditioner with care. 4 AC 12 10 8 6 MAN final 3/2/05 12:55 PM Page 7 ELECTRICAL SPECIFICATIONS 1. All wiring must comply with local and national electrical codes and must be installed by a licensed electrician. Once you have any questions regarding the following instructions, contact a licensed electrician. 2. Check available power supply and resolve any wiring problems BEFORE installing and operating this unit. 3. For your safety and protection. This unit is grounded through the power cord when plugged into a matching wall outlet. If you are not sure whether your wall outlet is properly grounded, please consult a licensed electrician. Electric Shock Hazard If the air conditioner has a serial plate rating of 115 volts and up to and including 7.5 amps the unit maybe on a fuse or circuit breaker with other devices. However, the maximum amps of all devices on that fuse or circuit breaker can not exceed the amps of the fuse of circuit breaker. If the air conditioner has a serial plate rating of 115 volts and greater than 7.5 amps it must have its own fuse or circuit breaker, and no other device or unit should be operated on the fuse or circuit breaker. To avoid the possibility of personal injury, disconnect power to the unit before installing or servicing. 4. The wall outlet(3-pin) must match the plug (3-pin) on the service cord supplied with the unit. DO NOT use plug adapters or extension cord. See (Table 1) for receptacle and fuse information. 5. The rating plate on the unit contains electrical and other technical data. The rating plate is located on the right side of the unit. Receptacle and Fuse Types Rated Volts 125 AMPS Fuse Size Time Delay Fuse (or circuit breaker) Wall Outlet 15 15 Plug type Table 1 5 AC 12 10 8 6 MAN final 3/2/05 12:55 PM Page 8 TIPS BEFORE INSTALLATION Your Room Air Conditioner unit is designed to be highly efficient and save energy. Follow these recommendations for greater efficiency. 1. Select the thermostat setting that suits your comfort needs and leave the thermostat at that chosen setting. 2. The filter is...

Скачать инструкцию

Чтобы скачать, введите 2 цифры: