Оценок - 5, средний балл: 4
(
)
)
|
Фрагмент инструкции
See FIG. 15. FIG. 15 THERMOSTAT WARM COOL Note: The thermostat does not control the unit optional electric heater if installed. B. Cooling Operation 1. Set the thermostat at the desired temperature level. 2. Select the fan speed that best satisfies your needs: a. HIGH COOL: Selected when maximum cooling and dehumidification required. b. MED COOL: Selected when normal or average cooling required. c. LOW COOL: Selected when room at desired comfort level and needs to be maintained. Normally this speed used for night time operation. Note: The blower runs continuously to circulate air and maintain an even temperature. The compressor will come on as cooling is required to maintain the selected temperature level. C. Fan Operation: 1. This will circulate the air in your RV without cooling or heating. There are three positions: HIGH FAN, MED FAN or LOW FAN to select from, depending upon personal choice. See FIG.14. D. Heating Operation: (With Optional Heat Kit Installed) Note: This electric heater will not replace a furnace for heating your RV in cold weather. The intent is to remove the chill on cool days or mornings. 1. Turn the selector switch to "OPT HEAT". See FIG. 14 2. The Heater will come on and begin heating. 3. When desired temperature level in RV is reached, move the selector switch to "OFF" or "FAN" position. Note: Thermostat does not control heater ON/OFF cycle.) E. "OFF" Position 1. This is to turn Unit off. G. Customer Maintenance 1. Periodically remove the return air filters located above the removable panels in the air box. Wash the filters with soap and warm water, let dry and the reinstall. Note: Never run the air conditioner without return air filter in place. This may plug the unit evaporator coil with dirt and may substantially affect the performance of the unit. 2. Clean air box housing and control panel with a soft cloth dampened with a mild detergent. Never use furniture polish or scouring powders. 3. The blower motor is factory lubricated and requires no service under normal use. 8 600312 & 600315 Series Installation Instructions 600312 & 600315 Series Installation Instructions . Under certain conditions, frost may form on the evaporator coil. If this should occur, inspect the filter and clean if dirty. Make sure air louvers are not obstructed. Air conditioners have a greater tendency to frost when the outside temperature is relatively low. This may be prevented by adjusting the thermostat control knob to a warmer setting (counter clockwise). Should frosting continue, operate on LOW, MED, or HIGH FAN only setting until the cooling coil is free of frost. 5. If your unit fails to operate or operated improperly, check the following before calling your service center. a. If RV connected to motor generator, check to be sure motor generator is running and producing power. b. If RV connected to power supply by a land line, check to be sure line is sized properly to run air conditioner load and it is plugged into power supply. c. Check y...
Эта инструкция также подходит к моделям:Кондиционеры - 600312.331 (173.59 kb)
Кондиционеры - 600315.331 (173.59 kb)
Кондиционеры - 600312.331 (173.59 kb)
Кондиционеры - 600315.331 (173.59 kb)