Оценок - 3, средний балл: 4.7
(
)
)
|
Фрагмент инструкции
(Fig. 3) Seal 21'' to 32'' 14'' Min 4. Measure the inside window sill width and find the center line as shown in Fig. 4. Center Line Fig. 4 Window installation step 2/5 '' Screws Fig. 2 9 INSTALLATION INSTRUCTIONS .WINDOW INSTALLATION STEP WAC 5 6 8 USER MAN final 3/2/05 12:23 PM Page 11 5. Install the L brackets on the outer sill with the short side of the bracket against the back of the inner sill. Install one L bracket 7.5 to each side of center line. See Fig. 5. Fig. 5 Center Line Short Side Bracket Inner Sill Outer Sill 7.5 7.5 6. Carefully lift the air conditioner and slide it into the open window. Make sure the bottom guide of the air conditioner drops into the notches of the L brackets. When the air conditioner drops into the L brackets, the air conditioner will be centered in window opening as show in Fig. 6. While steadying the air conditioner, carefully bring the window sash down behind the top channel of the air conditioner, as shown in Fig. 7. First, fix both sides onto the window sill with two 3/4 screws and one 2/5 screw ( which is unscrewed from each side of the unit). Then fix top channel to widow sash with one 3/4 screw and fix side curtain frames with four 3/4 screws as shown in Fig.6. Fig. 6 Fig.7 About 5 L Bracket Seal 7. If storm window presents interference, fasten a 2'' wide wood strip to the inner window sill across the full width of the sill. The wood strip should be thick enough to raise the height of the window sill so that the unit can be installed without interference from the storm window frame, as show in Fig. 8. Top of wood strip should be approximately 3/4'' higher than the storm window frame to help condensation to drain properly to the outside. Install a second wood strip (approximately 6'' long by 11/2''wide and same thickness as first strip) in the center of the outer sill flush against the back of the inner sill. Screw the L brackets into this strip. This will raise the L bracket as shown in Fig. 8. Fig.8 3/4''Clearance Storm window frame Inner sill Foam 3/4'' Screw 3/4'' Screw Mode Timer Fan Airconditioner 3/4 screw 3/4 screw 2/5 screw 3/4 screw 3/4 screw 3/4 screw 3/4 screw 3/4 screw 10 INSTALLATION INSTRUCTIONS WAC 5 6 8 USER MAN final 3/2/05 12:23 PM Page 12 Thermostat knob Mode knob When using FAN control, turn slowly allowing unit to adjust. When using THERMOSTAT, be sure to allow three minutes before changing temperature. Adjusting too quickly may cause an overload resulting in a blown fuse. ! CAUTION ! MODE Fig.9 The mode knob controls fan speeds and cooling speeds. To set desired cooling temperature, simply rotate the mode knob dial to the appropriate setting. See Fig. 9. LOW FAN will circulate the air at a minimum speed without cooling. HIGH FAN will circulate the air at a maximum speed without cooling. LOW COOL provides cooling, automatically with minimum air circulation. Recommended for nighttime use. HIGH COOL provides cooling, automatically with quick cooling or for extremely hot days. Once roo...
Эта инструкция также подходит к моделям:Кондиционеры - AAW-05CM1FHU (3.79 mb)
Кондиционеры - AAW-O6CM1FHU (3.79 mb)
Кондиционеры - AAW-05CM1FHU (3.79 mb)
Кондиционеры - AAW-06CR1FHU (3.79 mb)