Оценок - 0, средний балл: 0
(
)
)
|
К этому устройству также есть другие инструкции:
Компьютеры - HP Server rp7400 (609.06 kb)
Компьютеры - HP Server rp7400 (251.21 kb)
Фрагмент инструкции
WARNING
Only extend one SPU at a time. Never attempt to extend more that one SPU for any
reason.
Step 4.
Remove the PCI Cover Plate
NOTE
Steps 4 through 8 apply to the six PCI card slots on either side of the SPU. As viewed from
the rear of the cabinet, slots 1 through 6 are on the left side. The lowermost slot in the array
is slot 1. Slots 7 through 12 are on the right side, with slot 7 being the lowermost slot in the
array.
a. Loosen the two captive screws at the end of the I/O card slot cover.
b. Swing the cover away and off of the SPU.
Step 5.
Insert the I/O Card Into the Slot
NOTE
The PCI card slots have separators which protect against touching adjacent cards when
plugging in PCI cards. The separators also have tabs which facilitate removing the cards.
a. Remove the metal slot cover, if present, at the rear of the SPU.
b. Align the PCI card with the appropriate slot.
c. Insert the PCI card into the card cage, between the separator/extractor cards.
d. Press firmly on the PCI card to be sure it is fully seated.
Step 6.
Replace the PCI Cover Plate
a. Swing the I/O slot cover closed.
b. Tighten the two captive screws at the end of the slot cover.
NOTE
The PCI card slots have separators which protect against touching adjacent cards when
plugging in PCI cards. The separators also have tabs which facilitate removing the cards.
Step 7.
Insert the SPU Back Into the Cabinet
CAUTION
Be aware of the cables at the back of the SPU while moving the SPU in or out of the cabinet.
To insert the SPU into the cabinet from the back:
a. Carefully insert the SPU all the way into the cabinet until the front of the SPU sticks out the
front approximately 2 to 4 inches.
b. Align the left and right bezel bracket key slots over the three bracket screws on each side of
the SPU.
c. Slide the bezel brackets down and tighten the six (three on each side) bracket screws.
d. Carefully push the SPU back into the cabinet until the bezel brackets contact the cabinet
vertical rails.
29
...Эта инструкция также подходит к моделям:
Компьютеры - HP Server rp8420 (261.25 kb)