Войти:
Оценок - , средний балл: ( )

Инструкция по эксплуатации HP, модель HP 9000 rp8420-32 PA-8900 4x1.10GHz 3MB Server

Производитель: HP
Размер: 74.68 kb
Название файла:

Язык инструкции:en

Документ загружается, подождите пожалуйста
Документ загружается, подождите пожалуйста


К этому устройству также есть другие инструкции:

Фрагмент инструкции


HP AB322A 4 GB DIMM Installation Guide
NOTE
Failure to upgrade firmware might result in error messages displayed during the boot process.
Installing the 4 GB DIMMs
1. Follow proper procedures to shut down the operating system.
2. Remove the right side cover.
3. Power off the cell board using the PE command in the MP menu.
4. Verify that the green power LED on the cell board is off before removing the cell board.
5. Press each extraction lever and move the slide to the unlock position.
6. Pull out on each lever to unseat the cell board.
7. Slide the cell board from the chassis and place it on a flat, ESD surface.
8. Remove the DIMM cover.
9. Using both DIMM extraction tools (A5201-68005), place the grooved side of each tool on each side of the
target DIMM.
10. Seat the tool tips down to limit, then leverage connector latches outward to unseat the DIMM from the
memory slot.
11. Orient the replacement DIMM connector key over the memory slot.
12. Using the DIMM installer tool (A5201-68003), press the DIMM downward evenly to seat the DIMM into
the memory slot. Repeat for each additional DIMM to be installed.
NOTE
For best performance, the DIMMs should be installed in the following sequence: 0A-0B-1A-1B,
2A-2B-3A-3B, 4A-4B-5A-5B, 6A-6B-7A-7B.
13. Replace the DIMM cover.
14. Replace the cell board into the server. Ensure that the cell board is securely seated and both extraction
levers are in the locked position.
15. Power on the cell board using the PE command in the MP menu.
16. Replace the right side cover.
17. Power on the server and check that all memory is present. For example:
For PA-RISC servers boot to the BCH prompt and issue the IN ME command.
For IPF servers boot to the EFI shell and issue the info mem command.
18. Follow proper procedure to boot the operating system.
Part No.: AB322-96001
3


...

Эта инструкция также подходит к моделям:
Компьютеры - HP 9000 rp8420-32 PA-8900 8x1.10GHz 3MB Server (74.68 kb)
Компьютеры - HP 9000 rp8420-32 PA-8900 16x1.10GHz 3MB Server (74.68 kb)
Компьютеры - HP 9000 rp8420-32 PA-8900 32x1.10GHz 3MB Server (74.68 kb)
Компьютеры - HP Server rp7420 (74.68 kb)

Напишите ваш отзыв об устройстве



Текст отзыва
Ваше имя:
Введите две цифры:
capcha





Категории