Войти:
Оценок - 4, средний балл: 3.3 ( )

Инструкция по эксплуатации Acer, модель Veriton 3900Pro

Производитель: Acer
Размер: 10.48 mb
Название файла:
Язык инструкции:en
Перейти к скачиванию



Фрагмент инструкции


Read the 'Preinstallation instructions' on page 51. You need to open your computer before you can install additional components. See the following section for instructions: To remove the side panel 1 Turn off your computer and unplug all cables. 2 Place your computer on a flat, steady surface. 3 Turn the screws counterclockwise with your fingers to release the cover. 4 Hold right panel (from rear view) with both hands. Slide it back about an inch and then gently pull it outward to detach it. Veriton 6900Pro 57 Veriton 7900Pro To replace the side panel 1 Align the side panel's hinges to the housing frame and then push it in to slide it back into place. 2 Secure the side panels with the two screws. 58 4 Upgrading your computer Upgrading your computer Certain components of your computer are upgradeable, such as the memory, the hard disk, the CPU and the expansion cards. You need to observe the 'Installation precautions' on page 51 when installing or removing a computer component. However, for safety purposes, we do not recommend that you perform these upgrades yourself. If you want to replace or upgrade any of these components, contact your dealer or a qualified service technician for assistance. @........................................... Note: The mainboard model shown in the following figures may not be exactly the same as the one found in your computer. Installing additional memory The four 240-pin sockets on the mainboard support Double Data Rate 2 (DDR2) Synchronous Dynamic Random Access Memory (SDRAM)-type DIMMs. You may install 128 MB, 256 MB, 512 MB or 1 GB DIMMs for a maximum memory capacity of 4 GB. (see note) The DDR2 DIMMs require 1.8 volts. You can install PC2 3200/DDR2 400, or PC2 4200/DDR2 533 modules in the DDR2 DIMM sockets. Contact your dealer for qualified DIMM vendors. Each DDR2 DIMM socket is independent from the other. This independence allows you to install DDR2 DIMMs with different capacities to form different configurations. @........................................... Note: DDR2 667/800, 4 DIMM slots, expandable to 4 GB dualchannel memory To remove a DDR2 DIMM @........................................... Note: The DDR2 DIMM has only one notch located toward the center of the module. 1 Remove the side panel. 2 Locate the DDR2 DIMM socket on the mainboard. 59 3 Press the holding clips on both sides of the DDR2 DIMM socket outward to release the DDR2 DIMM (a). Gently pull the DDR2 DIMM out of the socket (b). To install a DDR2 DIMM 1 Locate the DDR2 DIMM socket on the mainboard. 2 Align the DDR2 DIMM with the socket (a). Press the DDR2 DIMM into the socket until the clips lock onto the DDR2 DIMM (b). @........................................ Note: The DDR2 DIMM sockets are slotted to ensure proper installation. If you insert a DDR2 DIMM but it does not fit easily 60 4 Upgrading your computer into the socket, turn the DDR2 DIMM around and try to insert it again. To reconfigure your computer Your computer automatically detects the amount of memory installed. Run the BIOS utility to view the new value for total system memory and make a note of it. Replacing the Veriton 3900Pro’s hard disk Follow these steps to replace your computer's hard disk: 1 Remove the computer cover (see page 53). 2 Detach all cables connected to the CD or DVD drive, the 3.5-inch floppy drive and hard disk. 61 62 4 Upgrading your computer 4 Pull out the drive rails that hold the hard disk to the housing. Set the drive rails aside. 5 Slide the hard disk frame to the left (d); then gently move it out (e) and pull it up to detach it (f). 6 Install the new hard disk into the housing. Secure it with the drive rails you removed earlier and connect the power and hard disk cables to the new hard disk. 7 Reinstall the drive frame into the housing. 8 Reattach the CD or DVD drive and the floppy drive cables. @.......................................... Note: Make sure that the other ends of the disk drive cables are securely connected to their corresponding connectors on the mainboard. 9 Replace the computer cover (see page 53). 63 Installing an expansion card To install an expansion card: Эта инструкция также подходит к моделям:
Компьютеры - Veriton 5900Pro (10.48 mb)
Компьютеры - Veriton 6900Pro (10.48 mb)
Компьютеры - Veriton 7900Pro (10.48 mb)


Напишите ваш отзыв об устройстве



Текст отзыва
Ваше имя:
Введите две цифры:
capcha





Категории