Оценок - 4, средний балл: 3.5 ( )

Производитель: Acer Размер: 279.67 kb Название файла: Язык инструкции:

Learn the locations of the buttons, ports and other hardware features. Computer rear view Icon Description Optical S/PDIF audio-out jack Coaxial S/PDIF audio-out jack PS/2 mouse port PS/2 keyboard port Serial port Parallel port VGA port IEEE 1394 port LAN port USB ports Audio jacks English Note: Configuration may vary by models . English English 6 Computer front view E series Description 1 Optical drive 2 Eject button for optical drive 3 Power button 4 USB ports 5 Speaker/ Headphone jack 6 Microphone-in jack 7 Indicators 8 FDD drive 9 Media card readers* 10 IEEE 1394 port Caution : Please insert the media cards upside down to avoid damaging your hardware. 7 Aspire E series English English English 8 Installing new components Make sure you only use components that are compatible with your Aspire computer. Consult your dealer about the suitability of new components before you purchase them. To ensure correct installation, refer to the documentation that comes with your new components before you start to add or replace components. Possible upgrade options include the following: • Replace the HDD with a higher capacity model, or add a second HDD. • Install additional memory. • Install a graphics card as a substitute for the embedded graphics subsystem. • Replace the CD drive with a DVD or CD-RW drive. • Install an add-on card, such as a fax/modem card, in one of the empty PCI slots. O pening The Case Before you open the case, turn your computer off and unplug the power cord from the wall outlet. a) Gently lay down the computer on a flat surface to access the side panel of the unit. b) Push the case lock to the right and pull the side panel toward you to remove the side panel. 9 Frequently asked questions The following questions are possible situations that may arise during the use of your computer and each is followed by easy answers and solutions to the situation. Q: I pressed the power switch but the system did not boot up. A: Check the LED located above the power switch. If the LED is not lit, no power is being applied to the system. Do any of the following: • Check if the voltage selector switch located on the rear panel of the computer is set to the correct voltage. • Check if you plugged the power cable properly into an electrical outlet. • If you are using a power strip or AVR, make sure that it is plugged in and turned on. If the LED is lit, check the following: • Is a non-bootable (non-system) diskette in the floppy drive? If yes, remove or replace it with a system diskette and press Ctrl + Alt + Del to restart your computer. • The operating system files may be damaged or missing. Insert the startup disk you created during Windows setup into the floppy drive and press Ctrl + Alt + Del to restart your computer. This will automatically diagnose your system and make necessary fixes. However, if the diagnostic utility still reports a problem, then you may have to perform the recovery process to restore your system to its ori...

Скачать инструкцию

Чтобы скачать, введите 2 цифры: