Оценок - 0, средний балл: 0
(
)
)
|
Фрагмент инструкции
u Please select Static, input all the parameters, and then click Apply. NOTE: Your service provider gives you the static address information. u Please select DHCP, and then click Apply. NOTE: Your service provider does not give you any parameters. • For 3G Gateway u Please select the WAN Connection Mode, and click Apply. 4. Begin to enjoy your Internet service. If you want to use Wi-Fi to connect to your router, please refer to the following steps. 1. Make sure that the WLAN works normally. Please check the Wi- Fi Setting on the WebGUI Configuration page or check the WIFI indicator. 2. Use your normal Wi-Fi application on the client to search for the available wireless networks. NOTE: Please set the client to obtain an IP address automatically, and the client will get an IP address like “192.168.0.101”. Wireless Connection (Optional) 3. Select the SSID of your device, and then click Connect. 5. Wait a moment, and then the client will connect to your device Troubleshooting Internet Related Problems Others Symptoms Possible Problems/ Solutions • Please check your configuration settings. I cannot access the • Please wait 1~ 2 minutes for the router to Internet at all. initialize. • Check your service indicators. The download or upload speeds are very slow. The speed is dependent on signal strength. Check your signal strength and network type. Can not visit the webGUI configuration page • Enter the correct address. The default address is • Only use one network adapter in your PC. • Do not use any proxy server. Can not establish the Wi-Fi connection between your device and client • Make sure the Wi-Fi function is active. • Refresh network list and select the correct SSID. • Check the IP address to make sure your client can obtain an IP address automatically in the Internet protocol (TCP/IP) properties. • Type the correct network key (Wi-Fi password) when you connect to the device. Cleaning and Maintaining • This warranty is End User’s sole remedy and ZTE’s sole liability successfully. Symptoms Possible Problems/ Solutions The 2G/3G signal • This indicates poor reception. Try indicator is always moving the router to another location blinking or does not light. near the window. About the password • For the Wi-Fi connection password, please check the label on the device. • The default password of the webGUI configuration page is admin. • If you changed the password and forgot the new password, you need to restore the device to the factory default settings. for defective or nonconforming items, and is in lieu of all other Warning and Notice • Use an antistatic cloth to clean the router. Do not use chemical or Safety Precautions warranties, expressed, implied or statutory, including but not Voice Related Problems abrasive cleanser as these could damage the plastic case. Turn off Symptoms Possible Problems/ Solutions • Please wait for 1~2 minutes after the There is no dial tone, when I lift the phone off the hook. router is turned...