Оценок - 3, средний балл: 3.3 ( )

Производитель: Black Box Размер: 1.54 mb Название файла: Язык инструкции:

• The LTD should only be used for storage, transport (LTDB), and charging of laptop computers, tablet PCs, ultra mobile PCs, and other similar devices. • Misuse, incorrect operation, or inadequate repair of the LTD will void the warranty. Chapter 3: Precautions LTD5 4.0 Configuration and Setup Remove and discard all packaging materials. Open and inspect the LTD or LTDB to verify all doors, drawers, and locks are working properly. For the LTDB, lock the casters prior to setting up, loading, or unloading laptop computers to prevent the LTDB from moving. Feed the power strip cord through the grommet hole located on the side of the LTD. Do not plug the LTD into the wall outlet until all configurations and setup are complete. Attach power bricks to the dividers to create separate slots for the laptop computers. 4.1 Installing Power Bricks on the Dividers Remove a divider to install a power brick on it. Follow these steps to install the power bricks on each divider: Step 1. Lay the divider flat on the work surface. Lay a laptop computer and a power brick on top of the divider, with the computer end of the power wire toward the top of the divider. Plug the power brick into the laptop computer. Lay the wire across the two holes at the top of the divider. Make sure that there is some slack between the front hole and the plug. Make sure there is slack at these two pointsNetbook Cord slackNote this pointPower BrickAlign the back of the notebook with the back of the divider Figure 4-1. How to thread the electrical cable through the dividers. Chapter 4: Configuration and Setup LTD5 Step 2. Note the point where the power wire meets the rear hole in the divider. Measure back 6" toward the power brick and fold the wire in half to create a loop in the center of the wire. This loop will be used in Step 3, below. Unplug the power wire from the netbook and remove the netbook from the divider. Figure 4-2. Loop the electrical cord and push it through the circular hole at the top rear of the divider. Step 3. Insert the loop created in Step 2 through the rear small hole at the top of the divider (Figure 4-2). Then, place the plug end of the wire through the loop (Figure 4-3). Make sure that the loop is on the side of the divider (not on top of it—see Figure 4-4). This will ensure that the divider will slide back into the cart. Then, tighten the loop down to the divider, tightening the knot. Figure 4-3. Insert the plug end of the wire through the loop. Keep the loop herePower brick end Figure 4-4. Make sure the loop is on the side of the divider, not on top of it. Step 4. Run the wire along the top of the divider and repeat the process of creating a loop in the power cord. Place this loop through the small hole at the front of the divider (Figure 4-5). Now place the plug end of the wire through the loop (Figure 4-6). Pull the end of the cable, tightening the loop (Figure 4-7). Chapter 4: Configuration and Setup LTD5 Figure 4-5. Create a loop from the power cable and feed...

Скачать инструкцию

Чтобы скачать, введите 2 цифры: