Войти:
Оценок - 2, средний балл: 4 ( )

Инструкция по эксплуатации Braun, модель KF 185

Производитель: Braun
Размер: 311.97 kb
Название файла: 273e327c-6743-93b4-bded-10533e3798b8.pdf
Язык инструкции:en
Перейти к скачиванию



Фрагмент инструкции


Caution Read all instructions before using this This appliance must kept out of the reach of children! Before plugging into a socket, check whether your voltage corresponds with the voltage printed on the bottom of the appliance. Do not put the carafe on other heated surfaces (such as stove plates, hot trays, etc.). Before you start preparing coffee a second time, always allow the coffeemaker to cool down approximately for 5 minutes between brewing (switch the appliance off), otherwise steam can develop when you pour cold water into the water container and this could cause scalding. The hotplate 9 heats up when the appliance is switched on. Avoid touching it and never let the cord come into contact with it. Braun electric appliances meet applicable safety standards. Repairs on electric appliances must only be done by authorised service personnel. Faulty, unqualified repair work may cause accidents or injury to the user. The cord of the appliance may only be replaced by an authorised Braun Service Centre as a special tool is required. Important This appliance was constructed to process normal household quantities. Always use cold water to make coffee. Warm water or other liquids could cause damage to the coffeemaker. Before using the first time, or when the coffeemaker has not been used for some time, fill the water container 3 to the maximum level with cold water (i.e. without coffee and without a filter). Turn on the coffeemaker and allow the water to flow through. Maximum cups 12 cups (125 ml each) 18 cups ( 83 ml each) Functions . AromaSelect feature . Time display (24 hour clock) . Manual operation . Automatic operation (24 hours) . Brewing small amounts (1 - 3 cups – 125 ml each) l Audio-visual «coffee . Automatic hotplate switch-(from 3.59 hours to 0.00 l Adjustable heating temperature °C) l Descaling/decalcifying control Description 1 Cord storage 2 Water level indicator 3 Water container 4 Space compensator D Water filter cartridge d Dial for water filter exchange 5 AromaSelect dial (mild taste = /strong taste = ) 6 Cover for the water container 7 Filter support bracket 8 Filter holder 9 Hotplate j Temperature sensor k Decalcifying indicator «calc» l Temperature selector «–temp.+» (for the hotplate 9 ) m Display n Button «h» (for setting the hours) o Button «min» (for setting the minutes) p Yellow control lamp (for the small amounts operation) q Button for the small amounts operation «1 - 3 » r Green control lamp (for the automatic operation) s Button for the «automatic» operation t «On/off» button u Red/green control lamp (for on/off setting and the automatic hotplate switch-off feature) Setting the clock Plug the appliance in. Three noughts appear on the display m of the electronic digital clock. To activate the timer, both buttons n and o must be pressed for at least 2 seconds each. Then press the buttons «h» n or «min» o as described below until the correct time of day appears on the display m . 5 seconds after the last adjustment, the coffeemaker will automatically return to the previous mode of operation. To set the correct time of day, first press the button «h» n to programme the hours. Then press the button «min» o to programme the minutes. Recommendation: Just before reaching the correct time, repeatedly press the buttons «h» and «min» without holding down to avoid going past the time required. The dots between the hours and minutes will flash once the clock has been programmed. 3 Note: If the power supply is pulled out of the socket, 15 minutes. All programmed stored for 15 minutes. Filling with coffee grounds Swing out the filter holder 8 (a) and insert the filter. Put coffee grounds (not ground too finely) filter and close the filter holder again (a) until snaps in place. Measure coffee according to strength desired. Filling with water Important: When filling with water and during coffee preparation either the space compensator 4 or the water filter cartridge D must be installed in the water container 3 . Otherwise the water level indicator 2 will not function correctly and the carafe may overflow. Fill the water container with as much cold water as coffee is required. To do this, lift the cover for the water container 6 and pour the cold water into the water container 3 . The amount of water is shown on the water level indicator 2 (maximum 12 cups – 125 ml each). Space compensator The space compensator 4 in the water container 3 takes up the space which is intended for the water filter cartridge D . Unless the water filter cartridge is installed in the water container, the space compensator must always be inside the water container when filling with water and brewing to avoid overfilling. Keep the space compensator as it has to be installed in the water container if you have to decalcify your coffeemaker. Water filter cartridge The water filter cartridge D is suitable for drinking-water only. It gives your purer tasting coffee by removing chlrorine, bad tastes and odors as well as scal...


Напишите ваш отзыв об устройстве



Текст отзыва
Ваше имя:
Введите две цифры:
capcha





Категории