Оценок - 2, средний балл: 4
(
)
)
|
Фрагмент инструкции
This is the only way to ensure optimum results and maximum safety. Using for the first time Carefully unpack the coffee maker and remove all the packaging material. Before using wash the accessories and surfaces. Do not immerse the coffee maker in water; simply wipe with a cloth and mild detergent if necessary. Do not put in the dishwasher or use harsh, abrasive cleaners. For the best tasting results prior to making coffee we recommend that you flush the coffee maker out with cold water only, without using coffee to remove any dust which may still be inside the coffee maker. To do this follow the directions ‘Preparing the coffee’. Installation • Place the coffee maker on a flat work surface at a safe distance from taps and sinks. • Check that the voltage corresponds to that indicated on the appliance rating plate.The appliance must always be connected to a well-earthed socket rated at 10A minimum.The manufacturer is not liable for damage caused by inadequate earthing of the appliance. • In the event of incompatibility between the plug on the appliance and the socket, have the plug replaced by a qualified service engineer. If the cable is damaged or requires replacing, contact a service centre authorised by the manufacturer only. • Never install the machine in an environment that can reach a temperature less than or equal to 0°C (the appliance may be damaged if the water freezes). 3 Coffee Maker EC5/7 fig. 7 Coffee Maker EC5/7 4 How to prepare the espresso coffee 1 Unscrew the water tank cap by turning it anti-clockwise. 2 Using the carafe supplied (fig. 1) pour water into the boiler (fig. 2) according to the amounts shown in the table on page 10. Do not exceed the amounts shown as this could cause the appliance to malfunction. While filling the boiler make sure the ON/OFF switch is in the OFF position. 3 Carefully close the boiler cap by turning it clockwise. 4 Insert the filter into the filter-holder. (fig. 3). 5 Fill the filter with ground coffee using the measures described in the table (page 10) about 7 g per cup. Fill the filter evenly in small doses to prevent the ground coffee from overflowing. (fig. 4). IMPORTANT: Before adding the ground coffee to the filter holder, make sure there is no coffee left from previous usage. It is important to use medium ground coffee. (Avoid using too finely ground coffee otherwise the filter can become blocked). 6 Remove any excess coffee from the filter rim (fig. 5). 7 Attach the filter holder to the machine by positioning the handle to the left of the boiler outlet, then pushing upwards and turning the handle to the right (fig. 6). 8 Place the carafe with the lid on the drip tray, make sure the nozzles on the filter holder fit inside the opening on the carafe’s lid (fig. 7). Make sure that the steam knob is turned off. 6 fig. 6 fig. 1 fig. 2 fig. 3 fig. 4 fig. 5 9 If the machine is supplied with a strength selector, position the lever according to the flavour of coffee desired, “light”,“medium” or “strong” (fig.8). 10 Press the ON/OFF switch (fig. 9). The switch will light up. 11 The coffee will start to flow after approximately three minutes. Turn off the power switch after sufficient coffee has been dispensed. 12 Before unscrewing the boiler cap or removing the filter holder, residual pressure must be released by slowly turning the steam knob (fig. 10) so that the residual steam can escape. Note: for safety reasons the cap turns freely and cannot be opened when the boiler is hot.The tank therefore cannot be refilled until all the water has been used or the boiler cools down (to make this a quicker process, open the steam knob). 13 To detach the filter holder, turn the handle from right to left. To remove the used coffee lock the filter with the built-in lever and let the coffee fall out by knocking the over turned filter holder. Coffee made directly into cups The carafe can be used to make 2 or 4 cups of coffee. If you prefer to make 2 cups only, fit the adaptor for cups to the lower section of the filter-holder (fig. 12) and place the cups directly underneath the nozzles. In this way, the coffee will flow directly into the cups. 1 fig. 10 fig. 11 fig. 12 5 Coffee Maker EC5/7 8 fig. 8 fig. 9 fig. 13 fig. 14 Making Cappuccino A cappuccino is an espresso coffee with a froth topping made by heating milk. • Fill a heat resistant container/jug with approximately 3 fl.oz. of cold milk for each cappuccino or refer to the table (page 10). The milk should be cold from the refrigerator and semi- skimmed as this gives the best results.When choosing the container bear in mind that the volume of milk will increase 2 or 3 times. Models without strength selector 1Follow the steps 1-10 in the paragraph "Making Espresso Coffee". Note that the amount of water needed to make 2 cups of cappuccino is greater than that required for 2 cups of normal coffee as it is also necessary to produce the steam to froth the milk. 2 Place the steam nozzle in the milk ensuring that the nozzle openin...