Оценок - 0, средний балл: 0
(
)
)
|
Фрагмент инструкции
Important: The Filter Yes/No setting controls the filter replacement indicator. Changing the filter setting >Turn the appliance off with the on/off switch. >Press and hold the temp. set button. >Turn the appliance back on with the on/ off switch – the M icon flashes. >Press the start/stop button to select the Filter Yes/No setting: Yes = M lights up or No = M does not light up >Release the temp. set button – the setting is now stored, and the most recently selected temperature lights up. Note: To change this setting at any time, repeat the above procedure. After setting the filter to “yes”, the symbol M will light up after a certain time during operation. The BRITA MAXTRA filter cartridge is exhausted and needs to be changed. Robert Bosch Hausgerate GmbH en To install a new filter cartridge, proceed as follows: Preparing and installing the BRITA MAXTRA filter cartridge >Remove the filter cartridge’s protective packaging. >Immerse the filter cartridge in cold tap water and shake it lightly (for about five seconds) to remove any air bubbles. >Take the filter holder out of the water tank and firmly insert the cartridge into the holder until you hear a click. >Hold the filter holder under the water tap and fill it with fresh, cold water; let the water run through the BRITA MAXTRA filter cartridge. >Repeat this procedure two or three times. >Place the filter holder with the filter cartridge back into its position in the empty water tank and fill the tank with cold tap water. >Hold down start/stop button for at least 2 seconds to delete M. Note: To replace the cartridge, simply pull on the strap attached to the top of the cartridge. When installing a new cartridge, follow the above steps for preparing and inserting a cartridge. Used BRITA MAXTRA water filter cartridges can be disposed of with the regular household garbage. If you have more questions, contact BRITA Consumer Service at 0844 742 4800 (toll-free). Important information – Always store spare filter cartridges sealed in the original packaging in a cool and dry place. – BRITA water filters are designed for use only with municipally treated tap water (note: this water is constantly controlled and according to legal regulations safe to drink) or with water from private supplies which has been tested as safe to drink. If an instruction is received from the authorities that mains water must be boiled, the BRITA filtered water must also be boiled. When the instruction to boil water is no longer in force, the appliance and filter funnel must be cleaned and a new cartridge inserted to ensure any residual contaminants are removed. – Please filter cold tap water only. – Clean the appliance and filter funnel regularly. – For certain groups of people (e.g. those with impaired immunity and for babies), it is generally recommended that tap water should be boiled; this also applies to BRITA filtered water. – For hygiene reasons, the MAXTRA cartridge contents are subject to special treatment with silver. A very small amount of silver may be transferred to the water. This transference would be within the World Health Organisation (WHO) guidelines. – During the filtering process, there may be a slight increase in potassium content. However, one litre of BRITA filtered water contains less potassium than e.g. an apple. If you have kidney disease and/ or follow a potassium restricted diet, we recommend that you consult your doctor before using a BRITA water filter. – Should your BRITA appliance not be in use for a prolonged period (e.g. holiday), BRITA recommends that you take out the cartridge, discard any water left inside the BRITA water filter and loosely insert the MAXTRA cartridge again. Before using the BRITA water filter again take out the cartridge, clean the appliance and funnel thoroughly and repeat the steps of the instructions for use in chapter: “Preparing and installing the BRITA MA XTRA filter cartridge”. – BRITA filtered water is dedicated for human consumption. It is a perishable food and as such please consume within 1 to 2 days. THD20.. 06/2012 en – Like each natural product, the consistency of the BRITA MicroporeFilter is subject to natural variances. This can lead to a slight abrasion of small carbon particles into your filtered water, noticeable as black bits. These particles have no negative health effects. If ingested, they will not harm the human body. In case you observe carbon particles, BRITA recommends to flush the cartridge several times or until the black bits disappear. – BRITA cannot accept responsibility or liability if you do not respect our recommendations for the use and exchange of the BRITA filter cartridge. Descaling Your appliance has an automatic descaling programme. When the N icon lights up, run the descaling programme as soon as possible. If the descaling programme is not run as instructed, the appliance may be damaged. Tip: With very hard, calciferous water, please descale the appliance more often than the N symbol is displayed...
Эта инструкция также подходит к моделям:Кофеварки - THD2021GB/03 (493.18 kb)
Кофеварки - THD2063GB/02 (493.18 kb)
Кофеварки - THD2063GB/03 (493.18 kb)