Оценок - , средний балл:
(
)
)
Производитель: Philips
Размер: 1.81 mb
Название файла:
Язык инструкции:
Документ загружается, подождите пожалуйста
 |
Документ загружается, подождите пожалуйста
Фрагмент инструкции
• To make coffee, you must drain the water by turning the steam knob (16) until only the tem- perature-ready LEDs (23) and (24) remain lit in a fixed way. 10 CLEANING AND MAINTENANCE General Cleaning • Maintenance and cleaning should only be carried out when the appliance is cold and disconnected from the power supply. • Do not immerse the appliance in water and do not wash the parts in the dishwasher. • Do not use abrasives or aggressive chemicals (solvents) for cleaning. • Do not dry the machine and/or any of its parts using a microwave and/or conventional oven. • We recommend you clean the water tank and change the water daily. • Clean the ground coffee doser daily. -Use the supplied brush to clean the doser (Fig.18). • To clean the appliance, use a soft cloth dampened with water (Fig.19). • Clean the service area and the coffee dispenser. • We recommend you empty and clean the drip tray (12) and the coffee grounds drawer (10) daily; to carry out this operation you must open the front cover (Fig.20) and remove the drip tray (Fig.21); then, you can empty and clean all the components. • You can remove the coffee dispenser in order to clean it (Fig.24): -lower the dispensing unit nozzles -take the dispensing unit as shown in Fig. 24, and remove it from its housing -wash the whole unit with warm water. 10.1 The coffee disperser The coffee dispenser (17) must be cleaned each time you fill the coffee bean container or, anyhow, at least once a week. • Switch off the appliance by pressing the ON/ OFF switch (7) to the “O” position and remove the plug from the wall outlet. • Open the service cover (15). Remove the drip tray (12) and the coffee grounds drawer. • Remove the coffee dispenser by holding it by its handle and pressing the “PUSH” • 30 • ENGLISH ENGLISH button (Fig.22) • Make sure that the two steel filters are free from any coffee residues. The top filter can be removed by unscrewing the plastic pin anticlockwise using the specific supplied key (Fig.23.). • Wash the coffee dispenser only with hot water: do not use detergents. Then accurately wash and dry all its components. • Refit the filter and carefully screw the plastic pin back on using the specific key. • Clean the compartment inside the appliance. • Holding it by its handle, insert the coffee dispenser into its housing until it snaps into place. • Insert the coffee grounds drawer, the drip tray plate and the drip tray. • Close the cover (15). 11 DESCALING Scaling occurs naturally when the appliance is used. Approximately every 3-4 months you should descale it; it is ready for descaling when you notice a reduction in the water flow or when the LED of the button (26) flashes. If you wish to carry this out at home, you can use a descaling product for coffee makers that is non toxic and/or not harmful and commonly available on the market. Caution! Never use vinegar. To descale the appliance proceed as follows: • Mix the descaler with water as specified on the package and fill the water tank. • Switch ON the appliance with the ON/OFF switch (7). • Press the button (26) for at least 5 seconds to select the descaling operating mode; the LED emits a fixed light. • Direct the steam nozzle (14) toward the drip tray. • Position a vessel of adequate capacity under the steam nozzle and turn the hot water knob anticlockwise (16). The appliance starts an automatic descaling cycle with pauses preset by the manufacturer and managed automatically by the appliance. • At the end of the cycle, the flow of the descaling solution is shut off and the 5 buttons start flashing simultaneously. • Turn the knob of the hot water nozzle (16) clockwise to OFF. In this case, also the warning light (27) flashes. • Rinse the water tank and fill it with fresh drinking water. • Position a vessel of adequate capacity under the steam nozzle and empty 2/3 of the contents of the water tank by turning the steam knob (16) anticlockwise; to shut off the flow, turn the knob (16) clockwise. • Let the appliance heat up and empty the remaining contents of the water tank by turning the steam knob (16) anticlockwise; to stop the flow, turn it clockwise. If you use a different product from the recommended one, we recommend you follow the instructions of the descaler manufacturer as specified on the package. If the descaling cycle is interrupted by switching the machine OFF, this is restarted when the machine is switched back ON. 12 FUNCTION PROGRAMMING The appliance allows you to programme some parameters depending on your needs. To programme the functions, you must enter programming mode as follows: • Ensure that the ON/OFF switch (7) of the appliance is switched to “O” and that the hot water knob (16) is OFF. • Press the buttons (23) and (25) and, at the same time, switch ON the appliance using the ON/OFF switch (7). You are now in the programming mode. To quit the programming mode and implement your changes, switch the machine OFF and, then, back ON again using the main switch (7). • 31 • ENGL...