Оценок - 3, средний балл: 4.3
(
)
)
|
Фрагмент инструкции
NOTE: Be sure to check the AM / PM indicator, located on the left side of the digital clock display. Then press the MIN button until the desired minutes have been reached. Release the PROG button. 3. Follow the “Operating Your Coffee Maker” steps 1 through 10. Then, press the ON-OFF / TIMER button only once, the TIMER light will illuminate. Your coffee maker is now set to start brewing at the programmed time. When the ON / OFF light illuminates, this indicates that your programmed brew time has now been activated. NOTE: If you wish to deactivate the TIMER function, press the ONOFF / TIMER button repeatedly until the TIMER light is no longer illuminated. 4. NOTE: If you wish to use the AROMA function, press the AROMA button immediately after TIMER light is illuminated. When the AROMA function is activated, the indicator will illuminate. NOTE: If the ON-OFF/ TIMER button is pressed before the PROG button, the TIMER function will not activate. OPERATING YOUR COFFEE MAKER PREPARING COFFEE MAKER FOR BREWING: 1. Place the coffee maker on a flat, level surface away from any edge. 2. Plug the unit into a 120V / 60Hz only outlet. 3. The lid of the carafe must be fitted properly during the brewing process. And the carafe must be set on the warming plate. 4. The filter basket door must be properly closed during the brewing process. CAUTION: If the filter basket door is not completely closed, the Pause ‘N Serve feature will not function properly. It could cause hot water or hot coffee to overflow. FILLING THE WATER RESERVOIR: Figure 5 5. Open the hinged water reservoir cover located at the top of the coffee maker. Fill the carafe with the desired amount of cold water. Empty the water from the carafe into the water reservoir. 6. Close the hinged lid. Place the carafe with the lid in place on the warming plate. FIGURE 5 -8 OPERATING YOUR COFFEE MAKER (continued) NOTE: The amount of brewed coffee after the brewing process is complete will always be slightly less than the amount of water placed in the coffee maker’s water reservoir, since some water is absorbed by the coffee grounds and filter. Add a little extra water at the beginning so that you have the exact number of cups desired. PREPARING THE COFFEE: 7. Swing the filter basket door outward to your left. The included permanent filter may be used instead of a paper filter. If using paper filters, insert a #4 cone- shaped filter into the filter basket before filling with coffee grounds. 8. Place the filter (either paper or permanent) into the filter basket. Then place the desired amount of ground coffee in the filter. According to coffee industry standards, use one standard coffee measure (2 level tablespoons) of coffee grounds for each six ounces of water. NOTE: We recommend using coffee grounds specifically for automatic drip coffee makers. After using your drip coffee maker several times, the coffee may be adjusted to suit your particular taste by decreasing or increasing the amount of coffee grounds used. 9. Swing the filter basket door closed and snap into place. CAUTION: Do not operate your coffee maker if the door does not close completely. If the door does not close completely, check to see that the filter basket is properly seated inside the filter basket holder, and snap door into place. 10. Close the hinged water reservoir cover. Place the carafe with the lid in place on the warming plate. 11. DC55TC Series: Press the ON-OFF / TIMER button and the TIMER light will illuminate. Press the ON-OFF / TIMER button again, and the ON-OFF light will illuminate indicating that the coffee maker has begun the brewing cycle. DC54TC Series: Press the ON-OFF button. The ON-OFF button will illuminate indicating the coffee maker is “on” and that the brewing process has started. FIGURE 6 -9 OPERATING YOUR COFFEE MAKER (continued) PREPARING THE COFFEE: 12. NOTE: If you wish to use the AROMA function, press the AROMA button immediately after ON-OFF light is illuminated. When the AROMA function is activated, the indicator will illuminate. 13. NOTE: If you would like a cup of coffee before the full pot is brewed, the Pause ‘N Serve feature allows you to interrupt the brewing process. The brewing process does not stop during this period; only the flow of coffee from the basket. Do not remove the carafe for longer than 30 seconds or the coffee may overflow from the basket stops. While we offer this feature, we do not recommend you pour coffee before the cycle has reached completion, since the coffee brewed at the beginning of the cycle has a flavor which is very different from the flavor at the end of the cycle. Removing a cup during the brewing cycle will alter the flavor of the finished pot. 14. Coffee is ready when “bubbling” sound and dripping have completely stopped. After the brew cycle is completed, the unit will automatically shut itself off. 15. The thermal carafe will keep coffee hot after brewing is complete. 16. Press the ON-OFF / TIMER button (DC55TC Series) or the ON-O...
Эта инструкция также подходит к моделям:Кофеварки - DC54TC Series (398.33 kb)