Оценок - 0, средний балл: 0
(
)
)
|
Фрагмент инструкции
Additional Information
Start ID writing is not possible during recording.
/ The start ID cannot be written within 9 seconds (18
Troubleshooting
seconds in long-play mode) after the end of the
previous start ID. Make sure at least 9 seconds (18
If you’ve experienced any of the following difficulties
seconds in the long-play mode) has passed after the last
while using the deck, use this section as a guide to
start ID and before writing a new one.
remedy the problem. Should any problem persist,
consult your nearest Sony dealer.
Direct Access does not work.
/ The specified program number does not exist on the
The cassette holder does not close.
tape. Press START ID RENUMBER to renumber the
/ Check that the cassette is inserted correctly (see pages 6
program numbers.
and 8).
/ The program numbers are out of order. Press START
/ Insert the cassette beyond the silver bar (see pages 6
ID RENUMBER to renumber the program numbers.
and 8).
The deck begins rewinding the tape during playback.
The function buttons do not work.
/ Repeat Play is on.
/ The deck has just been turned on and will not operate
Press REPEAT on the remote repeatedly to turn off
for about 4 seconds. Wait 4 seconds (10 seconds when
“REPEAT” or “REPEAT 1” in the display and cancel
“CLEANING” appears) before attempting any
Repeat Play.
operation.
/ The PAUSE P button is activated. Press PAUSE P to
The tape operation buttons do not function while writing
cancel pause.
or erasing a start ID.
/ The tape has reached its end. Press REW 0 to rewind
/ All buttons do not work during the 9 seconds the start
the tape.
ID is being written (18 seconds in long-play mode).
Wait until the writing the start ID finishes before
No sound
operation.
/ Make the proper connections (see page 5).
/ The connected amplifier is not being operated properly.
Absolute time codes writing is not possible.
Operate the amplifier as required for the respective
/ Recording began within a blank section.
deck operation. (Refer to the operating instructions of
Rewind the tape to its beginning, or locate the end of
the amplifier.)
the recorded portion with End Search before starting
recording.
The deck does not record.
/ The record-protect hole on the cassette is open. Slide
Tape transport is excessively loud during fast-forwarding
the record-protect tab to close the hole (see page 7).
or rewinding.
/ The INPUT switch is incorrectly set. Set INPUT to the
/ The noise is caused by the cassette and is not a
correct position.
mechanical problem.
/ The REC LEVEL control is set at 0. Turn REC LEVEL
clockwise to raise the recording level (only during
analog recording).
The tape stops suddenly.
/ The signal input to the digital input jack or connector is
/ The cassette is defective or damaged.
protected against digital copying
Press OPEN/CLOSE § and replace the cassette with a
(only during digital recording). Input the signal
new one.
through the analog input jack or connector.
When pressing REW 0/FF ) or PREVIOUS =/NEXT
The OPEN/CLOSE § button does not work.
+, the tape stops momentarily before starting to
/ The OPEN/CLOSE § button does not function during
move.
recording. Press STOP p or PAUSE P to stop
/ This is normal and is not a mechanical problem.
recording first, then press OPEN/CLOSE §.
The deck cannot be operated with the remote (supplied).
“CAUTION” appears and the deck cannot be operated.
/ The battery is weak. Change both batteries.
/ A safety mechanism is operating because of
condensation. Remove the cassette and leave the deck
“SBM” does not appear in the display even though SBM
turned on for about an hour. Then turn the deck off,
is set to ON.
then on again (see page 17).
/ ”SBM” appears only during the recording of analog
input signals with a sampling frequency of 48 kHz or
Sub codes writing is not possible.
44.1 kHz, not during the recording of a digital input
/ The record-protect hole on the cassette is open. Slide
signal, or an analog input signal with a sampling
the record-protect tab to close the hole (see page 7).
frequency of 32 kHz, or during playback.
19EN
3-856-761-11(2)
...