Оценок - 3, средний балл: 3.3
(
)
)
|
Фрагмент инструкции
OPERATING HEATER Your campfire burener is build to operate with natural gas or build for LP gas. This appliance is lit a piezo ignitor, follow these instructions exactly when lighting the campfire. BEFORE LIGHTING, smell arround the appliance the appliance area for gas. Be sure to smell to next to the ground as liquid propane gas heavier than air and will settle to the ground. Follow adaptable lighting instructions. Apply soap solution to all joints. Bubbles forming indicates a leak. Do not use a match or an open flame to detect leak. Light heater after ensuring that no gas leak exists. 7 LIGHTING INSTRUCTIONS WARNING:FOR YOUR SAFETY READ BEFOR LIGHTING 1. STOP! Read the safety information above. 2. Make sure manual shutoff valve is fully open. 3. Press in and turn control knob clockwise 90 degree to the OFF position. 4. Wait five (5) minutes to clear out any gas. Then smell for gas around log set and near floor. If you smell gas, STOP! Follow the safety information above. If you don’t smell gas, go on to the next step. 5. Turn control knob counterclockwise 90 degree to the PILOT position and press in. Keep control knob pressed in for five(5) seconds. Note: You may be running this log set for first time after hooking up to gas supply. If so, the control knob may need to be pressed in for 30 seconds. This will allow air to bleed from the gas system. 6. With control knob pressed in, push down and release ignitor button. This will light the pilot. The pilot is attached to the side of the front burner. If needed, keep pressing ignitor button until pilot lights. NOTE: If pilot does not stay lit, contact a qualified service person or PRO-COM’s 800# on the back of this manual. Until repairs are made, light pilot with the piezo. 7. Keep control knob pressed in for 30 seconds after lighting pilot. After 30 seconds, release control knob. Note: If pilot goes out, repeat steps 3 through 7. If control knob does not pop up when released, contact a qualified service person or PRO-COM’s 800# on the back of this manual. 8. Turn control knob counterclockwise 90 degree to the ON position. Burner should light. If burner does not light, call a qualified service person or PRO-COM’s 800# on the back of this manual. WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life. TO TURN OFF GAS TO APPLIANCE Shutting Off Appliance 1. Turn control knob clockwise 90 degrees to the PILOT position. 2. Press in and turn control knob clockwise 90 degrees to OFF position. Shutting Off Burner Only (pilot stays lit) Turn control knob clockwise 90 degrees to the PILOT position. Fig12 The operationg board MAINTENANCE AND STORAGE 1. Storage of an appliance indoors is permissible only if the gas supply system is disconnected and removed from the appliance. . 2. Have the heater inspected by qualified service man before each use or at least annually. 3. Check the POL fitting for any damage before each use and replace if any damage is found. 4. Spiders and insects can nest and live in outdoor appliances, especially in the burners and orifices. This will interrupt the normal flow of LP gas to the heater and can be a very dangerous situation. Inspect for insect infiltration of burner/orifice when one of the following occurs: A. The smell of gas along with predominating yellow tipping of the burner flames. B. Heater can not reach desired temperature. C. Uneven burner flow. D. Burner makes popping noises during normal use or shutdown. 5. Adopt rainproof cover (provided with the heater) to avoid rust of heater when not in use. 8 PRODUCT FEATURES SAFETY PILOT The heater has a pilot with a safety shutoff system. The safety pilot is a required feature for outdoor heaters. It shuts off the heater if flame is extinguished by rough wind. PIEZO IGNITION SYSTEM This heater has a piezo igniter. This system requires no matches, batteries, or other sources to light heater. VALVE CONTROL SYSTEM This heater has a control valve to control the gas flow, with the control valve, you can chose the proper flame of the fire. *Option Screen* For Your safety You may purchase the screen to maintain a clearance around the campfire CAUTION PLEASE DO NOT TOUCH SCREEN OR PLACE ANY OBJECTS ON SCREEN WHILE BURNER IS ON Children and adults should be alerted to the hazards of high surface temperatures and should stay away from SCREEN to avoid burns or clothing ignition, FIG. 13 The screen SERVICE INDICATIONS: A hazardous condition may result if a heater has been modified or is not functioning properly. When the heater is working properly: 1. The flame is essentially yellow. 2. There is no strong disagreeable odor, eye burning or other physical discomfort. 3. No smoke or soot exists internal or external to the campfire. 4. No unplanned or unexplained shut down of the heater occur. REPLACEMENT REPLACEMENT PARTS: Note: Use only original replacement parts. This will protect your warranty coverage for part...
Эта инструкция также подходит к моделям:Камины - PL600HYLA (518.8 kb)
Камины - PL600HYLB (518.8 kb)
Камины - PN750HYLB (518.8 kb)