Оценок - 3, средний балл: 4.3
(
)
)
|
Фрагмент инструкции
Figure 2 1 Montebello Series Andiron Kits Description Cat. No. Model Andiron Kit, Mission H2227 AKM-LSM Andiron Kit, Classic H2228 AKC-LSM WARNING: Burn hazard. Install only when fireplace is OFF and COLD. Step 1. If applicable, remove the mesh pull screens, as follows: Lift up the left side of the screen rod and slide it to the LEFT until the right side of the rod is disengaged from the hole. Slowly remove the rod and firescreens from the fireplace. Set aside in a safe location for later reinstallation. Step 2. Remove the glass door assembly, as follows: a. See Figure 2. While holding the top of the glass door frame in place, use a Phillips screwdriver to remove the two (2) screws securing the door frame to the two (2) door latches. b. Carefully swing the top of the glass door frame outward (as shown in Figure 2), and then lift the door assembly up and out of its lower track. c. Carefully set aside the glass door assembly in a safe location (on a padded surface) for later reinstallation. KIT CONTENTS (2) ea. Andirons (4) ea. Thumbscrews (2 attached to each andiron) REQUIRED TOOLS Phillips screwdriver DECORATIVE andiron KIT MONTEBELLO™ SERIES TM (2) Latch Screws Glass Door Assembly WARNING Hot GLASS WILL CAUSE BURNS. DO NOT TOUCH GLASS UNTIL COOLED. NEVER ALLOW CHILDREN TO TOUCH GLASS. • The surfaces on your fireplace get EXTREMELY HOT! • The glass on the front of the fireplace reaches EXTREMELY high emperatures and can cause severe burns if touched. Even after the gas is turned off, fireplace surfaces remain extremely hot. • Keep children away from an operating fireplace. Closely supervise children in any room where a fireplace is operating to prevent contact with glass. Risk of personal injury or property damage. • Never operate fireplace with glass door assembly removed. • Securely tighten door latch screws when reinstalling glass door assembly to prevent door from falling out. • Handle glass door assembly with extreme care. Replace damaged glass door assembly with approved replacement assembly only. The door assembly on this fireplace contains ceramic glass. Handle with care to prevent damage. If the door frame or glass becomes damaged, replace the entire glass door assembly with a manufacturer-approved replacement assembly only. Do not attempt to substitute any materials used on this door assembly or replace cracked or broken glass with any other materials. NOTICE • Read all steps before starting installation. • These instructions must be left with the appliance. • All warnings, precautions, and instructions in the Installation Instructions and Care and Operation Instructions provided with the appliance also apply to these instructions. • If you encounter any problems, need clarification of these instructions, or are not qualified to properly install this kit, contact your local distributor or dealer. Figure 1 Classic Andirons Mission Andirons (2) provided Thumbscrews per Andiron (both styles) GENERAL INFORMATION These decorative andiron kit...
Эта инструкция также подходит к моделям:Камины - AKM-LSM LSM40-2 (577.5 kb)
Камины - AKM-LSM LSM40ST (577.5 kb)
Камины - AKM-LSM LSM40ST-PV (577.5 kb)
Камины - AKM-LSM LSM45-PV (577.5 kb)