Оценок - 5, средний балл: 4.2
(
)
)
|
Фрагмент инструкции
* NOTE: The fireplace is equipped with a unit-mounted ON/OFF switch. In most installations this switch is not used. If you desire to use the switch and want to install these Style View Doors, you may desire to relocate the switch into the bracket provided on the door frame. This is OPTIONAL. If you desire to relocate the switch complete the optional procedures indicated by the asterisks below. Steps 2, 4 and 5 refer to ELDV Models only. For MPLDV Models, purchase a Rocker Switch kit model FRS (80L41). *2. Remove the Piezo / Switch Bracket from fireplace control compartment by pulling it forward as shown in Figure 2 (also see Figure 6). WARNINGS Hot! Do not touch! The decorative screen doors and the glass behind the screen doors will become hot during operation and will retain heat for a while after shutting off the appliance. Severe burns may result. Carefully supervise children in the same room as appliance. • These decorative screen doors are NOT heat guards and are not intended to prevent burns. • Operate the doors by only using the door handles. Avoid touching the doorframe, screens, or the glass enclosure, if the door is opened. • Use care when opening doors. Avoid exerting any downward pressure on the doors when they are in an open position. Excessive force can cause the doors to come loose or be damaged. • INSTALL ONLY WHEN THE FIREPLACE IS OFF AND COLD! Piezo & Switch Bracket Piezo & Switch Locating Bracket Figure 2 INSTALLATION INSTRUCTIONS: 1. Remove and retain the Lower Panel per instructions in Figure 1. *3. Disconnect the black and white wires from the ON/OFF switch. *4. Remove the ON/OFF switch from the bracket by squeezing the flex catches on sides of switch until it releases from bracket. *5. Reinstall the bracket with the piezo (reverse Step 2). 6. Remove Doorframe from packaging. Install as follows: *a. Position switch wires in front, inside of control compartment (so they can easily be reached after doorframe is in position). b.Position the bottom of the doorframe so that the bracket on the inside of the doorframe locks behind the cabinet bottom flange as shown in Figure 4. *c. Feed the switch wires through the switch mounting bracket on doorframe as shown in Figure 3. Retain the lower panel for future use in case the Style View Door Kit is ever removed. Wires for ON/OFF switch Switch Mounting Bracket on Doorframe Remove this lower panel by lifting it up and out. Figure 1 Figure 3 Tabs engage into slots (both sides) Hook Doorframe Over Glass door Slot Tab Fireplace Doorframe Locate the doorframe bracket on the lower front of the doorframe and lock it behind the cabinet bottom flange as shown here. Doorframe Bracket Figure 5 - MPLDV Models Detail Showing Glass Door Clip Being Put Into Place Between Doorframe And Glass Door Locate slot on each side Figure 4 - ELDV Models d. ELDV Models - Locate slots on each side of fireplace (see Figure 4). e. ELDV Models - Hold the top of the door frame slightly away from the fireplace front wh...
Эта инструкция также подходит к моделям:Камины - Merit Plus Series APDL35C (1.67 mb)
Камины - Merit Plus Series APDL35SP (1.67 mb)
Камины - Merit Plus Series APDL40C (1.67 mb)
Камины - Merit Plus Series APDL40SP (1.67 mb)