Оценок - 3, средний балл: 4
(
)
)
|
Фрагмент инструкции
Pull forward and lower the panel down to open. Remove the assembly from the fireplace by removing the hinge screw on each end of the assembly. Step 4. Working with one assembly at a time, remove the existing black louvers separating the brackets from the assemblies (see Figure 1). To ease the removal of the brackets, use a side bladed screwdriver and mallet to "tap" down the bend in each bracket finger (restore the bend by hand before reassembly). Replace the black louvers with the brass or brushed stainless louvers (without the pre-drilled holes) using the existing brackets. Step 5. Repeat Step 4 for the bottom louver assembly. Make sure to replace the pre-drilled black louver with the pre-drilled brass or brushed stainless louver. Existing Bracket Center Bracket (For No.’s H1526 thru H1529 Only) Existing Bracket Existing Bracket Figure 1 Center Bracket (For No.’s H1526 thru H1529 Only) Existing Bracket Louver (With Pre-Drilled Holes) Step 6. Remove logo from existing bottom louver with pre-drilled holes and then snap the logo into the brass or brushed stainless louver with pre-drilled holes. Step 7. Reinstall the louver assemblies, reusing the existing screws to reinstall the bottom assembly. NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. The manufacturer reserves the right to make changes at any time, without notice, in design, materials, specifications, prices and also to discontinue colors, styles and products. Consult your local distributor for fireplace code information. Printed in U.S.A. © 2004 by LHP P/N 750,166M REV. B 07/2006 LHP 1110 West Taft Avenue Orange, CA 92865...
Эта инструкция также подходит к моделям:Камины - H1526 (44.31 kb)
Камины - H1526 (44.31 kb)
Камины - H1526 (44.31 kb)
Камины - H1526 (44.31 kb)