Оценок - 3, средний балл: 3
(
)
)
|
Фрагмент инструкции
I). 2) Install the paper roll on the holders. 3) Insert the paper end into printer slot (Fig. II). 4) Press [ [~ri ] key to feed the paper to an adequate length. C. Replacing the Ink Roller If the printing becomes faint, the ink roller may need to be replaced. 1) Turn the power off. 2) Open the printer cover (Fig. III). 3) Remove the old ink roller by pulling it up (Fig. IV). 4) Insert the new ink roller IR-40T in the compartment and gently press it down until it snaps into place. E3 CAUTION: Turn the power off before replacing ink roller. DISPLAY SYMBOL MEMORY : A number has been stored in memory ERROR : Error or overflow of capacity : The display value is negative DATE AND TIME FUNCTION TIME/DATE: The TIME key is used to display the Time or Date. Depressing the TIME key once displays the date MM-DD-YYYY. Depressing the DATE key a second time displays the time, HH-MM-SS. SET: When displaying the Date or Time the = key becomes a key to enter or exit the date or time set mode. 12/24: When displaying the Time the key becomes a key to toggle between the 12 (AM/PM) or 24 hour clock mode. AM/PM: When displaying the Time in the set mode the x key becomes a key to toggle between AM and PM when in the 12 hour time mode. FORMAT: Used to select date format between “YYYY/MM/DD”, “DD/MM/YYYY” or “MM/DD/YYYY” at calendar mode. Set Date and Time 1) Press TIME/DATE and then SET (The first digit of the month will flash) 2) Enter the month MM using the number keys. (The first digit of the date will flash) 3) Enter the date DD using the number keys. (The first digit of the year will flash) 4) Enter the year YYYY using the number keys. (The first digit of the month will flash) 5) Press SET to confirm the date. 6) Press TIME/DATE and then SET. Enter the time using the number keys and press 12/24 to switch between 12-hour or 24-hour clock. 7) Press AM/PM to toggle morning or afternoon and press SET to confirm the time. E4 Problem Operation Read-out How to set date: Oct. 29, 2001 TIME/DATE SET (Hold 3 seconds) 10 29 2001 SET MM-DD-YYYY “M”M-DD-YYYY 10-”D”D-YYYY 10-29-”2”YYY “1 ”0-29-2001 10-29-2001 How to set time: a) 3:45AM b) 3:45PM c) 15:45 C/CE TIME/DATE TIME/DATE SET (Hold 3 seconds) 0345 SET SET (Hold 3 seconds) AM/PM SET 12/24 AM HH-MM-SS AM “H”H-MM AM “0”3-45 AM 03-45-00 AM “0”3-45 PM 03-45-00 15-45-00 DATE FORMAT: While displaying the date, depressing the %± key allows changing the date format mode from MM-DD-YYYY to DD-MM-YYYY or YYYY-MM-DD. The default date format is MM-DD-YYYY. REPLACING THE BACK-UP BATTERY 1) Using a screwdriver remove the three screws on the back cover of the calculator. 2) To separate the front and back cover halves, carefully insert and twist a flat-blade screwdriver between them. 3) Use a flat-blade screwdriver to gently pry out the battery. 4) Position the new battery so the positive (+) side is up. Slide one edge of the battery under the tab on the battery holder, then press the battery into place. 5) Snap the cover halves back together. Then reinsert and tighten the screws. NOTE: Memory backup battery retains the tax rate, calendar and clock setting, when the power is off or even when the AC cord is disconnected. Battery : 1 Lithium battery (Type: CR 2032) Battery life: Backup time 1000 hours RESET: Electromagnetic interference or electrostatic discharge may cause the display to malfunction or the contents of the memory to be lost or altered. Should this occur, use the tip of a ball point pen (or similar sharp object) to press the [RESET] button on the bottom of the calculator. After resetting, be sure to set the tax rate, time and date again. E5 CARACTERISTIQUES • Affichage • Vitesse d’impression • Papier d’impression • Alimentations • Température ambiante • Consommation • Dimensions • Rouleau encreur • Impression • Poids : Grand affichage a cristaux liquides de 12 chiffres : 2.7 lignes/seconde : Largeur de 57mm. (2 % pouces) : 1) 120V/60HZ (USA, CANADA) 2) 230V/50HZ (ECD) : 0° ~40°C (32° - 104°F) : 120V/0.12A/14.4W 230V/0.03A/6.9W 276mm (Long.) x 215mm (Larg.) x 62mm (H) IR-40T en deux couleurs En 2 couleurs (le moins et le négatif en rouge) 911g IDENTIFICATION DES TOUCHES ŒBD IC GT CAL SET m GT COST SELL MARGIN I A% I Íta5?+| tax- 8 #/P TIME/ /'DATE r FORMAT y I SET 1 %± 6 y %E X 0 oo + MT O/s MS */t M- M + IC GT CAL SET • (IC) Choisit le mode de comptage Articles Imprimante. • (GT) Commutateur de mémoire a choisir pour le Total Général. • (CAL) Choisit le mode de calcul normal. • (SET) Choisit le mode établi pour le taux d’imposition. A5/4T • ( A ) Une réponse est arrondie au chiffre supérieur. • (5/4) Une réponse est arrondie au chiffre inférieur. • ( y ) Une réponse est arrondie au chiffre inférieur. P NP :Commutateur pour choisir Imprimante en marche ou Imprimante a l’arrkt F1 А 0 2 3 4 F Réglage des décimales (A) comptable, Virgule fixe (0,2,3,4), (F) Virgule flottante [00] : Touch...